Daewoo Nubira. Manual — part 204
INTERIOR TRIM 9G – 17
DAEWOO V–121 BL4
3. Remove the bolts and the floor console forward trim
panels.
4. Remove the bolts securing the front portion of the
floor console.
5. Remove the shift lever boot, (if equipped).
6. Disconnect the power mirror control electrical con-
nector, if equipped.
7. Remove the the floor console.
Installation Procedure
1. Install the floor console.
2. Connect the power mirror control electrical connec-
tor, if equipped.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
3. Install the bolts to secure the front portion of the
floor console.
Tighten
Tighten the floor console bolts to 4 N
S
m (35 lb–in).
4. Install the floor console forward trim panels with the
bolts.
Tighten
Tighten the floor console forward trim panel bolts to
4 N
S
m (35 lb–in).
9G – 18
I
INTERIOR TRIM
DAEWOO V–121 BL4
5. Install the gear shift lever boot, (if equipped).
6. Install the bolts to secure the rear portion of the
floor console.
Tighten
Tighten the floor console bolts to 4 N
S
m (35 lb–in).
7. Connect the negative battery cable.
A–PILLAR TRIM PANEL
Removal Procedure
1. Pry off the A–pillar trim panel.
INTERIOR TRIM 9G – 19
DAEWOO V–121 BL4
Installation Procedure
1. Install the A–pillar trim panel.
C–PILLAR TRIM PANEL
(NOTCHBACK)
(Notchback Shown, Wagon Similar)
Removal Procedure
1. Reposition the plastic cap to reveal the C–pillar
seat belt anchor bolt.
2. Remove the bolt and the C–pillar seat belt anchor.
3. Remove the C–pillar trim panel from the body.
9G – 20
I
INTERIOR TRIM
DAEWOO V–121 BL4
Installation Procedure
1. Install the C–pillar seat belt anchor with the bolt.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
2. Install the C–pillar seat belt anchor with the bolt.
Tighten
Tighten the seat belt anchor bolt to 35 N
S
m (26 lb–ft).
3. Install the plastic cap to its original position.
C–PILLAR TRIM PANEL
(HATCHBACK)
Removal Procedure
1. Reposition the plastic cap to reveal the C–pillar
seat belt anchor bolt.
2. Remove the bolt and the C–pillar seat belt anchor.
3. Remove the rear speaker access cover.
4. Remove the screws and the C–pillar trim panel.
Installation Procedure
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
1. Install the C–pillar trim panel with the screws.
Tighten
Tighten the trim panel screws to 2 N
S
m (18 lb–in).
2. Install the rear speaker access cover.
3. Install the C–pillar seat belt anchor with the bolt.
Tighten
Tighten the seat belt anchor bolt to 35 N
S
m (26 lb–ft).
4. Install the plastic cap to its original position.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст