Daewoo Nubira. Manual — part 67
5C0 – 20
I
CLUTCH
DAEWOO V–121 BL4
4. Coat the piston rod bolt with multi–purpose grease.
5. Install the piston rod clevis, the piston rod bolt, and
the locking washer onto the clutch pedal.
6. Bleed the air. Refer to ”Air Bleeding” in this section.
7. Adjust the clutch pedal. Refer to ”Clutch Pedal Ad-
justment ” in this section.
8. Fill the reservoir with clutch/brake fluid up to the
MAX level.
9. Connect the negative battery cable.
CLUTCH RELEASE CYLINDER
ASSEMBLY
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the bolt and disconnect the hose from the
clutch release cylinder.
3. Remove the clutch release cylinder bolts and re-
move the release cylinder from the transaxle.
CLUTCH 5C0 – 21
DAEWOO V–121 BL4
Installation Procedure
1. Connect the release cylinder to the transaxle and
install the bolts.
Tighten
Tighten the release cylinder bolts to 60 N
S
m (44 lb–ft).
2. Connect the hose assembly to the cylinder body.
3. Apply grease where the pushrod connects to the
release lever. Be careful not to stain the boot.
4. Bleed the air. Refer to ”Air Bleeding” in this section.
5. Adjust the clutch pedal. Refer to ”Clutch Pedal Ad-
justment (Hydraulic)” in this section.
6. Fill the reservoir with clutch/brake fluid up to the
MAX level.
7. Connect the negative battery cable.
UNIT REPAIR
CLUTCH MASTER CYLINDER
Disassembly Procedure
1. Remove the clutch master cylinder assembly from
the vehicle. Refer to ”Clutch Master Cylinder As-
sembl” in this section.
2. Remove the boot and disconnect the piston stop
ring using ring pliers.
5C0 – 22
I
CLUTCH
DAEWOO V–121 BL4
3. Remove the pushrod assembly and the piston as-
sembly.
4. Inspect the cup and the piston for wear. Fluid leaks
will show wear on the cup and the piston. Replace
the cup and the piston if necessary.
5. Remove the pushrod assembly and the piston as-
sembly.
6. Inspect the pushrod for wear. Repair the pushrod if
necessary.
Assembly Procedure
1. Apply clean fluid to the piston assembly cup and
insert the piston assembly and the pushrod assem-
bly into the master cylinder body.
2. Install the piston stop ring using ring pliers. Install
the boot.
3. Install the clutch master cylinder assembly into the
vehicle. Refer to ”Clutch Master Cylinder Assembl”
in this section.
CLUTCH 5C0 – 23
DAEWOO V–121 BL4
CLUTCH RELEASE CYLINDER
Disassembly Procedure
1. Remove the clutch release cylinder assembly from
the vehicle. Refer to”Clutch Master Cylinder As-
sembl” in this section.
2. Remove the bolts and brackets.
3. Remove the boot and the pushrod.
4. Compress the piston with a driver, then remove the
snap ring with snap ring pliers.
5. Remove the piston assembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст