Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 468
SWITCH-IGNITION
REMOVAL
The ignition switch attaches to the lock cylinder housing on the end opposite the lock cylinder. For ignition switch
terminal and circuit identification, refer to the Wiring Diagrams section.
1. Disconnect negative cable from battery.
2. Remove the Instrument Panel Center Bezel, (Refer
to 23 - BODY/INSTRUMENT PANEL/CLUSTER
BEZEL - REMOVAL) Chrysler and (Refer to 23 -
BODY/INSTRUMENT PANEL/CLUSTER BEZEL -
REMOVAL) Dodge.
3. Bezel cluster removed.
8I - 50
IGNITION SYSTEM - SERVICE INFORMATION
LX
4. Remove side trim panel to steering column cover.
5. Remove the screws that secure the steering col-
umn cover to the instrument panel and relocate
panel.
6. Pull the steering column cover rearward at the top
and right side of the cover to release the snap
retainers from the instrument panel.
7. Remove the screws that secure the instrument
panel steering column cover reinforcement to
bracket and remove reinforcement from the vehicle.
LX
IGNITION SYSTEM - SERVICE INFORMATION
8I - 51
8. Remove the 2 front mounting nuts.
9. Remove the lower mounting nut.
10. Slide the assembly rearward into the instrument
panel and down to gain access to switch.
8I - 52
IGNITION SYSTEM - SERVICE INFORMATION
LX
11. Disconnect the electrical connector from the igni-
tion Switch and SKREEM Module.
12. Remove the interlock cable by depressing the
locking tab and pulling straight out.
LX
IGNITION SYSTEM - SERVICE INFORMATION
8I - 53
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст