Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 817
REAR WIPER MOTOR - WAGON ONLY
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the rear wiper arm (3) (Refer to 8 - ELEC-
TRICAL/WIPERS/WASHERS/WIPER
ARMS
-
REMOVAL).
3. Remove the liftgate trim panel (Refer to 23 - BODY/DECKLID/HATCH/LIFTGATE/TAILGATE/TRIM PANEL -
REMOVAL).
8R - 88
WIPERS/WASHERS - SERVICE INFORMATION
LX
4. Remove the three mounting fasteners (1).
5. Disconnect the electrical harness connector (5).
6. Separate the wiper motor (3) from the liftgate.
7. Inspect the wiper motor shaft to liftgate seal (1).
LX
WIPERS/WASHERS - SERVICE INFORMATION
8R - 89
INSTALLATION
1. Inspect the shaft-to-liftgate seal (1) in liftgate.
2. If seal is damaged, brittle, or deformed in any way
replace. Position shaft seal (1) with the arrow in the
UP position.
8R - 90
WIPERS/WASHERS - SERVICE INFORMATION
LX
3. Position wiper motor (3) in liftgate.
4. Install the mounting nuts (1). Torque nuts to 8 N·m
(70 in. lbs).
5. Connect the electrical harness connector (5).
LX
WIPERS/WASHERS - SERVICE INFORMATION
8R - 91
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст