Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 818
6. Install lower liftgate trim panel (Refer to 23 - BODY/DECKLID/HATCH/LIFTGATE/TAILGATE/TRIM PANEL -
INSTALLATION).
7. Install the rear wiper arm (Refer to 8 - ELECTRI-
CAL/WIPERS/WASHERS/WIPER ARMS - INSTAL-
LATION). Torque nut to 18 N·m (13 ft. lbs.).
8. Connect the battery negative cable.
8R - 92
WIPERS/WASHERS - SERVICE INFORMATION
LX
WASHER FLUID LEVEL SWITCH
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Drain washer fluid from the reservoir and into a
suitable clean container. This can be done by dis-
connecting the windshield washer hose from the
front (outboard) washer pump and allowing the
washer fluid to drain into a container through a
temporary jumper hose connected to the front
washer pump.
3. Remove the washer reservoir (Refer to 8 - ELEC-
TRICAL/WIPERS/WASHERS/WASHER
RESER-
VOIR - REMOVAL).
4. Remove the washer fluid level switch by pulling out
of reservoir. Inspect the grommet and if installing a
new switch, always use a new grommet.
LX
WIPERS/WASHERS - SERVICE INFORMATION
8R - 93
INSTALLATION
1. Inspect grommet and if installing new switch, use a
new grommet. Position the switch into opening and
firmly press into place.
2. Install the washer reservoir (Refer to 8 - ELECTRI-
CAL/WIPERS/WASHERS/WASHER RESERVOIR -
INSTALLATION).
3. Refill the reservoir with fluid drained previously.
4. Connect the battery negative cable.
8R - 94
WIPERS/WASHERS - SERVICE INFORMATION
LX
WASHER PUMP MOTOR
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Drain washer fluid from the reservoir and into a
suitable clean container. This can be done by dis-
connecting the windshield washer hose from the
front (outboard) washer pump and allowing the
washer fluid to drain into a container through a
temporary jumper hose connected to the front
washer pump.
3. Remove the washer reservoir (Refer to 8 - ELEC-
TRICAL/WIPERS/WASHERS/WASHER
RESER-
VOIR - REMOVAL).
4. Remove the washer pump motor by pulling out of
reservoir. Inspect the grommet and if installing a
new motor, always use a new grommet.
LX
WIPERS/WASHERS - SERVICE INFORMATION
8R - 95
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст