Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 815
9. Install and tighten the nut to the bellcrank.
10. Install the front wiper module (3) (Refer to 8 -
ELECTRICAL/WIPERS/WASHERS/WIPER MOD-
ULE - INSTALLATION).
11. Connect the battery negative cable.
8R - 80
WIPERS/WASHERS - SERVICE INFORMATION
LX
HEADLAMP WASHER
DESCRIPTION
The headlamp washers work in conjunction with the
windshield
washers. The
headlamp
washers
are
enabled with the headlamps “ON” and the front wind-
shield washers activated. With the windshield washers
activated the headlamp washers will spray twice for a
predetermined amount of time.
OPERATION
The headlamp washer system utilizes a separate high pressure pump that is attached to the windshield washer
reservoir. The headlamp washer pump feeds nozzles that are mounted in the front fascia of the vehicle. The nozzles
are aimed in front of the headlamp assembly. These nozzles spray the headlamps when the system is activated.
To activate the headlamp washers, turn ON the headlamps and then press the front windshield washer control knob.
This will operate the windshield washers and direct one, timed high pressure sprays onto the headlamp lens.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Loosen front fascia as necessary on the side to be
removed (Refer to 13 - FRAME & BUMPERS/
BUMPERS/FRONT FASCIA - REMOVAL).
3. Disconnect
washer
hose
(2)
from
headlamp
washer.
4. Remove headlamp washer from front fascia (1).
LX
WIPERS/WASHERS - SERVICE INFORMATION
8R - 81
INSTALLATION
1. Install headlamp washer to front fascia (1).
2. Attache washer hose (2) to headlamp washer fitting
(3).
3. Install front fascia (1) (Refer to 13 - FRAME &
BUMPERS/BUMPERS/FRONT FASCIA - INSTAL-
LATION).
4. Connect battery negative cable.
8R - 82
WIPERS/WASHERS - SERVICE INFORMATION
LX
HEADLAMP WASHER HOSE
REMOVAL
The headlamp washer hose (2) is a special high pres-
sure hose with specific fittings (3), and must be
replaced as a unit.
1. Disconnect and isolate the battery negative cable.
2. Loosen up the fascia (1) on the side of the vehicle
in which hose needs replacing (Refer to 13 -
FRAME & BUMPERS/BUMPERS/FRONT FASCIA -
REMOVAL).
3. When disconnecting hose (2) , press down firmly
on latch (3) at headlamp washer pump motor and
washer assembly and pull apart.
INSTALLATION
The headlamp washer hose is a special high pressure
hose with specific fittings, and must be replaced as a
unit.
1. Install the new high pressure headlamp washer
hose (2) assembly. Push fitting (3) on until a snap
is heard.
2. Install the fascia (Refer to 13 - FRAME &
BUMPERS/BUMPERS/FRONT FASCIA - INSTAL-
LATION).
3. Connect the battery negative cable.
LX
WIPERS/WASHERS - SERVICE INFORMATION
8R - 83
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст