Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1474
12. Raise vehicle.
13. Align flexplate and torque converter.
NOTE: Make sure all four bolts are installed finger
tight before torqueing bolts.
14. Tighten torque converter bolts to 75 N·m (55 ft.
lbs.).
15. Using a block of wood and a suitable lifting device
under the oil pan, raise the engine.
16. Install the structural collar (3) and position in
place.
NOTE: Make sure that structural collar (3) is flush
with the oil pan (1) and the transmission bell
housing.
17. Finger tighten all bolts (2) & (4).
18. Tighten the structural collar to oil pan bolts (2) to
55 N·m (40 ft. lbs.).
19. Tighten structural collar to transmission bolts (4) to 55 N·m (40 ft. lbs.).
20. Install the power steering pump (3).
21. Install the A/C compressor (4) (Refer to 24 -
HEATING & AIR CONDITIONING/PLUMBING/A/C
COMPRESSOR - INSTALLATION).
9 - 1920
ENGINE - 2.7L DOHC - SERVICE INFORMATION
LX
22. Install the crankshaft position sensor and connect
electrical connector (Refer to 14 - FUEL SYSTEM/
FUEL
INJECTION/CRANKSHAFT
POSITION
SENSOR - INSTALLATION).
23. Connect
oil
pressure
sensor
(1)
electrical
connector.
24. Install starter (2), tighten bolts to 41 N·m (30 ft.
lbs.)
25. Connect electrical connectors at starter.
26. Connect the coolant pipe (1) to coolant hose.
27. Connect the exhaust pipes to the manifolds.
28. Connect the down stream oxygen sensor connec-
tors.
29. Connect A/C compressor electrical connetors.
LX
ENGINE - 2.7L DOHC - SERVICE INFORMATION
9 - 1921
30. Install new oil filter (3).
31. Install lower splash shield (2) and tighten retaining
bolts (1).
32. Lower vehicle.
33. Install power steering pump (3) (Refer to 19 -
STEERING/PUMP - INSTALLATION).
34. Connect lines to power steering pump (3).
35. Install accessory drive belt (5) (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
INSTALLATION).
9 - 1922
ENGINE - 2.7L DOHC - SERVICE INFORMATION
LX
36. Install air cleaner housing assembly (3) (Refer to
9 - ENGINE/AIR INTAKE SYSTEM/AIR CLEANER
HOUSING - INSTALLATION).
37. Connect intake air temperature sensor connector.
38. Connect negative battery (1) cable.
39. Fill coolant system (Refer to 7 - COOLING -
STANDARD PROCEDURE).
40. Fill engine with correct grade of oil (5).
41. Install strut tower support (2).
42. Install cowl screen (1).
43. Install wiper arms (Refer to 8 - ELECTRICAL/
WIPERS/WASHERS/WIPER ARMS - INSTALLA-
TION).
44. Install the hood.
LX
ENGINE - 2.7L DOHC - SERVICE INFORMATION
9 - 1923
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст