Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1844
12. Install the driver airbag (3). (Refer to 8 - ELEC-
TRICAL/RESTRAINTS/DRIVER
AIRBAG
-
INSTALLATION)
13. Install the negative battery terminal on the battery.
It is important that this is performed properly
(including calibration of steering angle sensor if
equipped with ESP). (Refer to 8 - ELECTRICAL/
BATTERY SYSTEM - STANDARD PROCEDURE)
14. Test the operation of the horn, lights and any
other functions that are steering column operated.
19 - 194
COLUMN SERVICE INFORMATION
LX
WHEEL-STEERING
REMOVAL
WARNING: Before servicing the steering column the airbag system must be disarmed. Refer to electrical
restraint system for service procedures. Failure to do so may result in accidental deployment of the airbag
and possible personal injury.
CAUTION: All fasteners must be torqued to specification to ensure proper operation of the steering column.
1. Position the front wheels straight-ahead.
2. Fully extend or pull out adjustable steering column.
3. Disconnect the negative (ground) cable from the
battery.
4. Remove the airbag (3). (Refer to 8 - ELECTRICAL/
RESTRAINTS/DRIVER AIRBAG - REMOVAL).
5. Remove the steering wheel retainer bolt (2), then
slide the steering wheel (1) off the shaft.
6. If wheel is being replaced, transfer attached com-
ponents as necessary.
INSTALLATION
1. Align the spline on the steering wheel hub to the
column shaft, then install the steering wheel (1).
2. Install a NEW retainer bolt (2). Tighten the bolt to
70 N·m (52 ft. lbs.).
LX
COLUMN SERVICE INFORMATION
19 - 195
3. Install the airbag (3). (Refer to 8 - ELECTRICAL/
RESTRAINTS/DRIVER AIRBAG - INSTALLATION)
4. Install the negative battery terminal on the battery.
It is important that this is performed properly
(including calibration of steering angle sensor if
equipped with ESP). (Refer to 8 - ELECTRICAL/
BATTERY SYSTEM - STANDARD PROCEDURE)
CAUTION: If the steering wheel is excessively off-
center while driving, outside of Chassis specifica-
tions, inadvertent ESP activations may occur on a
vehicle so equipped.
5. Test the operation of the horn, lights and any other
functions that are steering column operated.
19 - 196
COLUMN SERVICE INFORMATION
LX
GEAR
TABLE OF CONTENTS
page
page
GEAR
DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 198
REMOVAL
TIE ROD - OUTER
OUTER TIE ROD END . . . . . . . . . . . . . . . . . . . . . . 211
LX
GEAR
19 - 197
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст