Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1505
4. Remove lower splash shield retaining bolts (1) and
splash shield (2).
5. Drain engine oil (5) and remove oil filter (3).
9 - 2044
ENGINE - 2.7L DOHC - SERVICE INFORMATION
LX
6. Remove the steering coupler bolt (4) and separate
coupler (1) from rack (3).
7. Disconnect power steering pressure switch electri-
cal connector (1).
LX
ENGINE - 2.7L DOHC - SERVICE INFORMATION
9 - 2045
8. Remove steering rack mounting bolts (1).
9. Remove power steering line support (2) from
frame.
10. Reposition rack out of the way.
11. Remove structural collar (Refer to 9 - ENGINE/
ENGINE
BLOCK/STRUCTURAL
COVER
-
REMOVAL).
12. Remove mounting bracket to oil pan lower bolt
(1).
13. Remove A/C compressor bracket to oil pan lower
bolt (2).
9 - 2046
ENGINE - 2.7L DOHC - SERVICE INFORMATION
LX
14. Remove lower timing chain cover to oil pan bolts
(1).
CAUTION: Assure removal of the four lower timing
cover bolts, as damage to the timing cover and/or
oil pan may occur.
15. Remove oil pan and gasket.
INSTALLATION
1. Clean oil pan and sealing surfaces. Inspect timing
chain cover gaskets. Replace as necessary.
2. Apply an 1/8 inch bead of Mopar
T
Engine RTV
GEN II to the front T-joints (1) (oil pan gasket to
timing cover gasket interface) and the rear T-joints
(2) (oil pan gasket to crankshaft rear oil seal
retainer gasket interface).
3. Install oil pan gasket to block.
NOTE: To prevent oil leaks at oil pan to timing
chain cover, the following tightening sequence
procedure must be performed.
LX
ENGINE - 2.7L DOHC - SERVICE INFORMATION
9 - 2047
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст