Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2118
DECKLID
REMOVAL
1. Open the deck lid.
2. Disconnect and isolate the battery negative cable.
3. Remove the cover from over the latch on the inside
of the deck lid. (Refer to 23 - BODY/DECKLID/
COVER - DECKLID LATCH - REMOVAL).
4. Disconnect the connector (2) of the body wire har-
ness take out for the deck lid (1) from the latch
connector receptacle (3).
5. Disengage the two retainers (4) that secure the
deck lid take out (2) of the body wire harness to
the underside of the deck lid.
6. Disengage the wire grommet (1) near the right
hinge from the underside of the deck lid.
7. Carefully remove the deck lid take out of the body
wire harness from between the inner and outer
deck lid panels.
23 - 20
DECKLID
LX
8. Mark both upper hinge bracket (3) locations on the
deck lid inner panel (1) to aid reinstallation.
9. With the aid of an assistant, support the deck lid
while removing the two screws (2) that secure each
upper hinge bracket to the deck lid.
10. Remove the deck lid from the vehicle.
INSTALLATION
1. With the aid of an assistant, support and position
the deck lid (1) to the two upper hinge brackets (3)
on the vehicle.
2. Install and tighten the two screws (2) that secure
each upper hinge bracket to the deck lid. Tighten
the screws to 28 N·m (21 ft. lbs.).
LX
DECKLID
23 - 21
3. Carefully route the deck lid take out (2) of the body
wire harness between the inner and outer deck lid
panels.
4. Engage the wire grommet (1) into the hole near the
right hinge on the underside of the deck lid.
5. Engage the two retainers (4) that secure the deck
lid take out (2) of the body wire harness to the
underside of the deck lid.
6. Reconnect the connector (2) of the body wire har-
ness take out for the deck lid (1) to the latch con-
nector receptacle (3).
7. Reinstall the cover over the latch on the inside of
the deck lid. (Refer to 23 - BODY/DECKLID/
COVER - DECKLID LATCH - INSTALLATION).
8. Reconnect the battery negative cable.
9. Close the deck lid.
10. Adjust the deck lid hinge positions and upper
overslam
bumpers
as
necessary
to
achieve
proper spacing and operation.
23 - 22
DECKLID
LX
HINGE
REMOVAL
1. Open and support the deck lid (1) with a suitable
prop or block.
2. Remove the support cylinder from the deck lid
hinge. (Refer to 23 - BODY/DECKLID/CYLINDER -
DECKLID SUPPORT - REMOVAL).
3. Mark the upper hinge bracket (3) location on the
deck lid inner panel to aid reinstallation.
4. Remove the two screws (2) that secure the hinge
to the deck lid.
5. Mark the lower hinge bracket (1) location on the
deck lid opening drain trough to aid reinstallation.
6. Remove the three screws (2) that secure the hinge
to the drain trough.
7. Remove the deck lid hinge from the vehicle.
LX
DECKLID
23 - 23
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст