Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2120
SUPPORT CYLINDER
REMOVAL
1. Open and support the deck lid with a suitable prop
or block.
WARNING: To avoid personal injury or death, dur-
ing service lift the ball socket end retaining clip
only far enough to release the socket from the ball
stud. Excessive prying or removal of the clip may
result in improper clip spring tension. Improper
clip tension may result in the support cylinder
separating from the ball stud causing sudden,
unexpected loss of deck lid support.
2. Insert a small flat-bladed tool (3) into the notch on
the outer face of one ball socket end (1) of the
support cylinder and carefully pry the retaining clip
(2) outward while pulling the ball socket away from
the ball stud (4) on the deck lid hinge.
3. Release the retaining clip to its installed position.
4. Repeat Step 2 and Step 3 for the opposite end of
the support cylinder.
5. Remove the support cylinder (2) from the deck lid
hinge (1).
23 - 28
DECKLID
LX
INSTALLATION
1. Position the ball socket on the cylinder end of the
support cylinder (2) to the ball stud on the upper
bracket of the deck lid hinge (1).
2. Using hand pressure, press the ball socket onto
the ball stud until the retainer clip snaps into place.
3. Position the ball socket on the rod end of the sup-
port cylinder to the ball stud on the lower bracket of
the deck lid hinge.
4. Using hand pressure, press the ball socket onto
the ball stud until the retainer clip snaps into place.
5. Inspect to be certain that the retaining clip on each
of the support cylinder ball socket ends is fully
seated.
6. Remove the service prop or block and close the
deck lid.
LX
DECKLID
23 - 29
DECKLID - SPOILER
REMOVAL
NOTE: On SRT 8 vehicles only.
1. Remove spoiler nuts from spoiler studs..
2. Remove spoiler (1) from decklid (2).
INSTALLATION
NOTE: SRT 8 vehicles only
1. Insert spoiler studs through decklid (2) holes.
2. Install nuts (3) to spoiler studs.
3. Torque nuts to 6 N·m (4.4 ft. lbs.)
23 - 30
DECKLID
LX
DOOR - FRONT
TABLE OF CONTENTS
page
page
DOOR - FRONT
DESCRIPTION - FASTENER . . . . . . . . . . . . . . . . . . . 32
DOOR
EXTERIOR HANDLE
GLASS
HINGE
LATCH
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47
LOCK CYLINDER
STRIKER
TRIM PANEL
WATERSHIELD
WINDOW REGULATOR
LX
DOOR - FRONT
23 - 31
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст