Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1852
12. Remove two previously loosened pump mounting
bolts (1) and remove power steering pump (2)
from engine.
NOTE: The drive pulley is not serviced separately
from the power steering pump.
INSTALLATION
2.7L/3.5L
1. Align pump (3) with mounting holes on engine
bracket (2).
2. Install three pump mounting bolts (1) through
access holes in pulley and engine bracket. Tighten
bolts to 28 N·m (21 ft. lbs.) torque.
19 - 226
PUMP
LX
NOTE: Always use a NEW O-ring on the end of the
pressure hose.
3. Lubricate NEW O-ring on end of pressure hose
with clean power steering fluid.
4. Install pressure hose (2) to pump (1). Tighten pres-
sure hose tube nut to 47 N·m (35 ft. lbs.) torque.
5. Install supply hose (3) on pump. Install clamp (2)
securing hose in place.
6. Install serpentine drive belt. (Refer to 7 - COOL-
ING/ACCESSORY DRIVE/DRIVE BELTS - INSTAL-
LATION)
7. Install air cleaner housing and inlet tube. (Refer to
9 - ENGINE/AIR INTAKE SYSTEM/AIR CLEANER
HOUSING - INSTALLATION)
8. Connect battery negative cable (2) to battery post.
It is important that this is performed properly. (Refer
to 8 - ELECTRICAL/BATTERY SYSTEM - STAN-
DARD PROCEDURE)
9. Fill pump reservoir with fluid and perform pump ini-
tial operation procedure. (Refer to 19 - STEERING/
PUMP - STANDARD PROCEDURE)
LX
PUMP
19 - 227
5.7L/6.1L
1. Align pump (1) with mounting holes on engine.
2. Install three pump mounting bolts (2) through
access holes in pulley. Tighten bolts to 28 N·m (21
ft. lbs.) torque.
NOTE: Always use a NEW O-ring on the end of the
pressure hose.
3. Lubricate NEW O-ring on end of pressure hose
with clean power steering fluid.
4. Install pressure hose (2) to pump (1). Tighten pres-
sure hose tube nut to 47 N·m (35 ft. lbs.) torque.
19 - 228
PUMP
LX
5. Install supply hose (3) on pump (1). Install clamp
securing hose in place.
6. Install serpentine drive belt. (Refer to 7 - COOL-
ING/ACCESSORY DRIVE/DRIVE BELTS - INSTAL-
LATION)
7. Install air cleaner housing and inlet tube. (Refer to
9 - ENGINE/AIR INTAKE SYSTEM/AIR CLEANER
HOUSING - INSTALLATION)
8. Connect battery negative cable (2) to battery post.
It is important that this is performed properly. (Refer
to 8 - ELECTRICAL/BATTERY SYSTEM - STAN-
DARD PROCEDURE)
9. Fill pump reservoir with fluid and perform pump ini-
tial operation procedure. (Refer to 19 - STEERING/
PUMP - STANDARD PROCEDURE)
LX
PUMP
19 - 229
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст