Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1827
29. Remove the lower steering column mounting pivot
bolt and nut (2).
CAUTION: When handling the steering column use
care to avoid holding the column by any part of
the tilt/telescope mechanism or by the shaft boot.
The column should be held by its mounting
bracket and the shaft by the exposed portions.
30. Remove the two upper mounting screws (1) from
the steering column (2).
31. Lower the steering column assembly to access
the park lock cable.
CAUTION: Before removing the park lock (inter-
lock) cable, make sure the ignition key is removed
or placed in LOCK position. If otherwise, damage
to the park lock system may occur.
32. Remove the park lock (interlock) cable housing
(1) from the column.
33. Remove the park lock cable button (2) from the
lever.
34. Remove the steering column assembly from the
vehicle.
35. If necessary, transfer any parts to the new
column.
19 - 126
COLUMN SERVICE INFORMATION
LX
COLUMN - RHD
WARNING: Before servicing the steering column the airbag system must be disarmed. Refer to electrical
restraint system for service procedures. Failure to do so may result in accidental deployment of the airbag
and possible personal injury.
CAUTION: All fasteners must be torqued to specification to ensure proper operation of the steering column.
1. Position the front wheels straight-ahead.
2. Disconnect the negative (ground) cable from the battery.
3. Remove the airbag (3). (Refer to 8 - ELECTRICAL/
RESTRAINTS/DRIVER AIRBAG - REMOVAL).
4. Remove the steering wheel retainer bolt (2), then
slide the steering wheel (3) off the steering column
(1) shaft.
LX
COLUMN SERVICE INFORMATION
19 - 127
5. Remove the steering column opening cover (1).
(Refer
to
23
-
BODY/INSTRUMENT
PANEL/
STEERING
COLUMN
OPENING
COVER
-
REMOVAL)
6. Remove the steering column opening reinforce-
ment (3).
7. Remove two left side parking brake lever mounting
nuts (8) and loosen the right lower mounting nut
(5). Remove the lever from the studs (2, 3) and
move it down, away from the column.
19 - 128
COLUMN SERVICE INFORMATION
LX
8. Loosen any one of the three clockspring screws
(1). The others may be left in.
9. Back out the set screw (1) through the access hole
(3) in the steering column control module (SCCM)
(2) securing the multi-function SCCM assembly.
10. Pull the SCCM assembly (1) off the steering col-
umn shaft.
11. Remove the instrument cluster bezel. (Refer to 23 - BODY/INSTRUMENT PANEL/CLUSTER BEZEL -
REMOVAL)
LX
COLUMN SERVICE INFORMATION
19 - 129
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст