Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1828
12. Unsnap and move the adjustment handle locking
tab (3) forward as shown unlatching the handle
(2) from the column.
13. Remove the four roll top shroud mounting screws
and remove the shroud (1).
14. Remove the instrument cluster assembly. (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - REMOVAL)
15. Depress the tabs on the rear of the column wiring
harness connector and remove the connector
from the steering column.
19 - 130
COLUMN SERVICE INFORMATION
LX
16. Remove the pinch bolt (3) securing the intermedi-
ate shaft to the steering column shaft (1).
17. Slide the intermediate shaft (2) off the steering
column shaft (1).
18. Remove the lower steering column mounting pivot
bolt and nut (2).
LX
COLUMN SERVICE INFORMATION
19 - 131
CAUTION: When handling the steering column use
care to avoid holding the column by any part of
the tilt/telescope mechanism. The column should
be held by its mounting bracket.
19. Remove the two upper mounting screws (1) from
the steering column (2).
20. Remove the steering column assembly from the
vehicle.
21. Transfer any remaining parts if necessary to the
new column.
INSTALLATION
COLUMN
WARNING: Before servicing the steering column the airbag system must be disarmed. Refer to electrical
restraint system for service procedures. Failure to do so may result in accidental deployment of the airbag
and possible personal injury.
CAUTION: When handling the steering column use care to avoid holding the column by any part of the
tilt/telescope mechanism or by the shaft boot. The column should be held by its mounting bracket and the
shaft by the exposed portions.
CAUTION: All fasteners must be torqued to specification to ensure proper operation of the steering column.
NOTE: New bolts must be used for installation.
19 - 132
COLUMN SERVICE INFORMATION
LX
1. Position the steering column (2) on the instrument
panel and loosely install the upper mounting
screws (1).
2. Firmly slide the steering column upward against the
instrument panel and loosely install the pivot bolt
and nut (2).
LX
COLUMN SERVICE INFORMATION
19 - 133
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст