Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1833
4. Tighten
the
steering
column
upper
mounting
screws (1) to 30 N·m (22 ft. lbs.).
5. Tighten the pivot bolt (2) to 30 N·m (22 ft. lbs.).
19 - 150
COLUMN SERVICE INFORMATION
LX
6. Align the intermediate shaft upper coupling (3) with
the steering column shaft plastic alignment fin (2),
then carefully slide the intermediate shaft onto the
column shaft (1).
7. Install a NEW steering intermediate shaft pinch bolt
(3). Tighten the pinch bolt to 31 N·m (23 ft. lbs.).
8. Install the steering column wiring harness connec-
tor into the holder on the steering column. Make
sure the connector is captured in the holder.
9. Install the instrument cluster assembly. (Refer to 8 -
ELECTRICAL/INSTRUMENT
CLUSTER
-
INSTALLATION)
10. Place the roll top shroud (1) over the steering col-
umn (2).
LX
COLUMN SERVICE INFORMATION
19 - 151
11. Install the four shroud mounting screws (2) (two
screws each side).
12. Position the manual adjustment handle (2) over
the column adjustment pin and rotate the locking
tab (3) rearward as shown latching the handle to
the column. Make sure the tab snaps into locked
position.
13. Install the instrument cluster bezel. (Refer to 23 - BODY/INSTRUMENT PANEL/CLUSTER BEZEL - INSTAL-
LATION)
14. Slide the SCCM assembly (1) onto the steering
column.
19 - 152
COLUMN SERVICE INFORMATION
LX
15. Tighten the set screw (1) securing the SCCM
assembly (2).
16. Tighten the clockspring screw(s) (1) that were
backed
out
to
keep
the
clockspring
from
unwinding.
LX
COLUMN SERVICE INFORMATION
19 - 153
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст