Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1831
CAUTION: When handling the steering column,
care must be taken not to squeeze the boot or dis-
tort the seal to the body.
6. Center the boot for the steering column at the bulk-
head (2). Install and tighten the two mounting nuts
(1) to 7 N·m (62 in. lbs.).
7. Raise and support the vehicle.
8. Check and make sure the plastic collar (2) on the
column shaft is engaged in the groove within the
boot (1).
9. Align the pin on the steering shaft with the nut in
the lower coupling shaft and slide the steering shaft
(3) into the lower coupling (5).
10. Install a NEW pinch bolt (4). Tighten pinch bolt to
31 N·m (23 ft. lbs.).
11. Lower the vehicle.
19 - 142
COLUMN SERVICE INFORMATION
LX
12. Install the shift cable (2) in the mounting bracket
(3).
13. Connect the shift cable (2) to the shift mechanism
(1).
14. Install the steering column wiring harness connector into the holder on the steering column. Make sure the
connector is captured in the holder.
15. Install the instrument cluster (but not cluster bezel). (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER -
INSTALLATION)
16. Position the roll top shroud (1) and install the
three mounting screws.
LX
COLUMN SERVICE INFORMATION
19 - 143
17. Position the manual adjustment handle (2) over
the column adjustment pin and rotate the locking
tab (3) rearward as shown latching the handle to
the column. Make sure the tab snaps into locked
position.
18. Install the cluster bezel (3). (Refer to 23 - BODY/
INSTRUMENT
PANEL/CLUSTER
BEZEL
-
INSTALLATION)
19. Slide the gear shift lever (2) into the column shift
mechanism.
20. Line up the threaded hole in the lever with the
hole in the shift mechanism and install the gear
shift lever mounting screw (1). Tighten the screw
to 12 N·m (106 in. lbs.).
21. Route the autostick wiring down the right side of
the column and secure to the column using a wir-
ing tie strap (2).
22. Connect the autostick wiring connector (1).
23. Connect the 6-Way electronic shift module wiring
connector (4).
19 - 144
COLUMN SERVICE INFORMATION
LX
24. Slide the gear shift lever boot down gear shift
lever (1) and snap it into place on the cluster
bezel (3).
25. Install the SCCM assembly (1) onto the steering
column.
26. Tighten the set screw (1) securing the SCCM
assembly (2).
LX
COLUMN SERVICE INFORMATION
19 - 145
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст