Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1834
17. Position the parking brake lever over the mount-
ing studs (2, 3) and install the two left side park-
ing brake lever mounting nuts (8) and the right
lower mounting nut (5). Tighten the mounting nuts
to 26 N·m (19 ft. lbs.).
18. Install the steering column opening reinforcement
(3). Tighten the bolts to 8 N·m (71 in. lbs.).
19. Install the steering column opening cover (1).
(Refer to 23 - BODY/INSTRUMENT PANEL/
STEERING
COLUMN
OPENING
COVER
-
INSTALLATION)
19 - 154
COLUMN SERVICE INFORMATION
LX
20. Align the spline on the steering wheel (3) hub to
the steering column (1) shaft.
21. Install the steering wheel (3) and install a NEW
retainer bolt (2). Tighten the bolt to 70 N·m (52 ft.
lbs.).
22. Install the airbag (3). (Refer to 8 - ELECTRICAL/
RESTRAINTS/DRIVER
AIRBAG
-
INSTALLA-
TION)
23. Install the negative battery terminal on the battery.
It is important that this is performed properly
(including calibration of steering angle sensor if
equipped with ESP). (Refer to 8 - ELECTRICAL/
BATTERY SYSTEM - STANDARD PROCEDURE)
24. If new, initialize the shaft lock module using a
scan tool.
CAUTION: If the steering wheel is excessively off-
center while driving, outside of Chassis specifica-
tions, inadvertent ESP activations may occur.
25. Test the operation of the horn, lights and any
other functions that are steering column operated.
LX
COLUMN SERVICE INFORMATION
19 - 155
SPECIFICATIONS
STEERING COLUMN FASTENER TORQUE
DESCRIPTION
N·m
Ft. Lbs.
In. Lbs.
DASH SEAL MOUNTING NUTS
7
—
62
GEAR SHIFT LEVER MOUNTING
SCREW
12
9
106
STEERING COLUMN BRACE
MOUNTING SCREW - AT COLUMN
29
21
255
STEERING COLUMN BRACE
MOUNTING SCREW - AT SUPPORT
BEAM
12
9
106
STEERING COLUMN LOWER PIVOT
BOLT
30
22
265
STEERING COLUMN UPPER
MOUNTING SCREWS
30
22
265
STEERING COUPLING PINCH BOLT -
AT GEAR
54
40
—
STEERING COUPLING PINCH BOLT -
AT UPPER COUPLING/INTERMEDIATE
SHAFT
31
23
—
STEERING INTERMEDIATE SHAFT
PINCH BOLT - AT RHD COLUMN
31
23
—
STEERING WHEEL RETAINER BOLT
70
52
—
19 - 156
COLUMN SERVICE INFORMATION
LX
COUPLING-STEERING
REMOVAL
1. Fully extend or pull out adjustable steering column.
2. Center the steering wheel and lock the steering wheel with a steering wheel holder.
3. Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)
4. Remove the pinch bolt (4) connecting the steering
shaft (3) to the lower steering coupling shaft (5).
5. Separate the lower coupling (5) from the steering
shaft (3).
6. Remove the pinch bolt (1) from the steering cou-
pling (2) at the steering gear (3).
7. Carefully slide the coupling (2) from the steering
gear (3).
8. Remove the steering coupling (2) from the vehicle.
LX
COLUMN SERVICE INFORMATION
19 - 157
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст