Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1830
18. Tighten clockspring screw(s) (1) that were backed
out to keep the clockspring from unwinding.
19. Install the steering column opening reinforcement
(1).
19 - 138
COLUMN SERVICE INFORMATION
LX
20. Install the steering column opening cover (1).
21. Align the spline on the steering wheel hub to
shaft.
22. Install the steering wheel (1) and install a NEW
retainer bolt (2). Tighten the bolt to 70 N·m (52 ft.
lbs.).
LX
COLUMN SERVICE INFORMATION
19 - 139
23. Install the airbag (3). (Refer to 8 - ELECTRICAL/
RESTRAINTS/DRIVER
AIRBAG
-
INSTALLA-
TION)
24. Install the negative battery terminal on the battery.
It is important that this is performed properly
(including calibration of steering angle sensor if
equipped with ESP). (Refer to 8 - ELECTRICAL/
BATTERY SYSTEM - STANDARD PROCEDURE)
CAUTION: If the steering wheel is excessively off-
center while driving, outside of Chassis specifica-
tions, inadvertent ESP activations may occur on a
vehicle so equipped.
25. Test the operation of the horn, lights and any
other functions that are steering column operated.
COLUMN - COLUMN SHIFT
WARNING: Before servicing the steering column the airbag system must be disarmed. Refer to electrical
restraint system for service procedures. Failure to do so may result in accidental deployment of the airbag
and possible personal injury.
CAUTION: When handling the steering column use care to avoid holding the column by any part of the
tilt/telescope mechanism or by the shaft boot. The column should be held by its mounting bracket and the
shaft by the exposed portions.
CAUTION: All fasteners must be torqued to specification to ensure proper operation of the steering column.
NOTE: New bolts must be used for installation.
1. Firmly slide the steering column upward against the
instrument panel and loosely install the pivot bolt
and nut (2).
19 - 140
COLUMN SERVICE INFORMATION
LX
2. install the park lock (interlock) cable end button (2)
on the lever.
3. Install the park lock cable (1) on the column.
4. Raise the steering column assembly (2) into place
on the instrument panel and install the upper
mounting screws (1). Tighten the steering column
upper mounting screws (1) to 30 N·m (22 ft. lbs.).
5. Tighten the pivot bolt (2) to 30 N·m (22 ft. lbs.).
LX
COLUMN SERVICE INFORMATION
19 - 141
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст