Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1829
3. Tighten
the
steering
column
upper
mounting
screws (1) to 30 N·m (22 ft. lbs.).
4. Tighten the pivot bolt (2) to 30 N·m (22 ft. lbs.).
19 - 134
COLUMN SERVICE INFORMATION
LX
5. If equipped with electronic telescoping column,
Install the screws (3) fastening the brace (1) to the
steering column (2) and support beam bracket.
First, tighten mounting screw at the column to 29
N·m (21 ft. lbs.). Then, tighten mounting screw at
the support beam to 12 N·m (106 in. lbs.).
CAUTION: When handling the steering column,
care must be taken not to squeeze the boot or dis-
tort the seal to the body.
6. Center the boot for the steering column at the bulk-
head (2). Install and tighten the two mounting nuts
(1) to 7 N·m (62 in. lbs.).
7. Raise and support vehicle.
8. Check and make sure plastic collar (2) on column
shaft is engaged in groove within boot (1).
LX
COLUMN SERVICE INFORMATION
19 - 135
9. Align the pin on the steering shaft with the nut in
the lower coupling shaft and slide the steering shaft
(3) into the lower coupling (5).
10. Install a NEW pinch bolt (4). Tighten pinch bolt to
31 N·m (23 ft. lbs.).
11. Lower the vehicle.
12. Install the steering column wiring harness connector into the holder on the steering column. Make sure the
connector is captured in the holder.
13. Install the instrument cluster. (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - INSTALLATION)
14. Position the roll top shroud (1) and install the four
mounting screws.
19 - 136
COLUMN SERVICE INFORMATION
LX
15. Manual tilt and telescoping columns – Position the
manual adjustment handle (2) over the column
adjustment pin and rotate the locking tab (3) rear-
ward as shown latching the handle to the column.
Make sure the tab snaps into locked position.
16. Install the SCCM assembly (1) onto the steering
column.
17. Tighten the set screw (1) securing the SCCM
assembly (2).
LX
COLUMN SERVICE INFORMATION
19 - 137
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст