Chrysler New Yorker. Manual — part 68
INSTRUMENT PANEL AND SYSTEMS
CONTENTS
page
page
DESCRIPTION AND OPERATION
CLOCK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
ELECTRO–MECHANICAL INSTRUMENT
CLUSTER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
REMOVAL AND INSTALLATION
ATC SUN SENSOR . . . . . . . . . . . . . . . . . . . . . . . 2
CLOCK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
CLUSTER LAMPS . . . . . . . . . . . . . . . . . . . . . . . . 6
TRACTION CONTROL SWITCH . . . . . . . . . . . . . . 7
UPPER RIGHT TRIM BEZEL . . . . . . . . . . . . . . . . 7
DESCRIPTION AND OPERATION
CLOCK
The clock is of analog type mounted in the instru-
ment panel center air distribution bezel (Fig. 1).
Refer to the Owner’s Manual for setting instruc-
tions.
ELECTRO–MECHANICAL INSTRUMENT CLUSTER
The mechanical instrument cluster is an electro-
mechanical module which receives most of its infor-
mation
via
the
Programmable
Communication
Interface (PCI) bus.
There are three types of clusters: (Fig. 2), (Fig. 3)
and (Fig. 4):
• Speedometer
• Tachometer
• Odometer/trip odometer
• Fuel gauge
• Temperature gauge
• Electronic transmission range
The warning and information indicators include
the following:
• Check Engine
• Airbag
• Charging system
• Low oil pressure
• High temperature
• Low fuel
• Seat belt
• Cruise
• Brake/park brake
• High beam
Fig. 1 Analog Clock
Fig. 2 Cluster – Intrepid
Fig. 3 Cluster – Concorde
Fig. 4 Cluster – LHS and 300M
300M
INSTRUMENT PANEL AND SYSTEMS
8E - 1
• Turn signals
• Door Ajar
• Decklid Ajar
• ABS (optional)
• Traction Control Active (optional)
• Traction Control Off (optional)
• Low Washer Fluid
The gauges are the magnetic air-core type. When
the ignition switch is OFF, the gauge pointers should
rest at or below the low graduation.
REMOVAL AND INSTALLATION
ATC SUN SENSOR
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Remove the instrument top cover, refer to (Fig.
6), (Fig. 7) and (Fig. 8).
(3) Remove the two sun sensor mounting screws.
(4) Disconnect the wire connector and remove the
sensor (Fig. 5).
INSTALLATION
For installation, reverse the above procedures.
Fig. 5 ATC Sun Sensor
8E - 2
INSTRUMENT PANEL AND SYSTEMS
300M
DESCRIPTION AND OPERATION (Continued)
Fig. 6 Instrument Panel Components – Intrepid
300M
INSTRUMENT PANEL AND SYSTEMS
8E - 3
REMOVAL AND INSTALLATION (Continued)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст