Chrysler Crossfire. Manual — part 143
3. Install the air tube assembly (1) by installing the
retaining bolts (2).
4. Install the engine cover (1). Align engine cover
retaining clips to the rubber mounts, and push
down firmly to connect engine cover to rubber
mounts.
Note: To ease the installation of the engine cover,
apply a small amount of lubricant to the engine
cover rubber mounts.
ZH
ACCESSORY DRIVE
7 - 107
TRANSMISSION
TABLE OF CONTENTS
page
page
TRANSMISSION COOLER LINES
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 108
. . . . . . . . . . . . . . . . . . . . . . . . 109
TRANSMISSION COOLER LINES
REMOVAL
Note: To service the front copper transmission cooler lines (5) the radiator must be removed. (Refer to 7 -
COOLING/ENGINE/RADIATOR - REMOVAL).
1. Raise and support the vehicle.
2. Remove the lower splash shield.
3. Disconnect the fittings at either end of the line being serviced.
4. Remove the line retainers (1) and the cooler line(s) as necessary.
7 - 108
TRANSMISSION
ZH
INSTALLATION
1. Position the cooler line(s) and loosely connect the fittings.
2. Install the retainers and bolts for the cooler line(s).
Note: Replace the copper washers if the banjo bolts are removed.
3. Tighten the cooler line fittings or banjo bolts to 20 N·m (15 ft. lbs.).
4. Tighten the transmission cooler line retaining bolts to 10 N·m (89 in. lbs.).
5. Lower the vehicle.
6. Install the radiator if removed. (Refer to 7 - COOLING/ENGINE/RADIATOR - INSTALLATION).
7. Check the transmission fluid level. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1/FLUID -
STANDARD PROCEDURE).
ZH
TRANSMISSION
7 - 109
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст