Chrysler 300M, Dodge Interpid. Manual — part 361
(d) Press and hold the bracket in place for at
least one minute.
NOTE: Verify that the mirror support bracket is cor-
rectly aligned, because the adhesive will cure rap-
idly.
(7) Allow the adhesive to cure for 8-10 minutes.
Remove any excess adhesive with an alcohol-damp-
ened cloth.
(8) Allow the adhesive to cure for an additional
8-10 minutes before installing the mirror.
REAR SEAT GRAB HANDLE/
READING LAMP
REMOVAL
(1) Pull down coat hook.
(2) Remove screw attaching assist handle to roof
from behind coat hook.
(3) Pull and hold assist handle down.
(4) Remove front screw attaching assist handle to
roof (Fig. 24).
(5) Remove assist handle from roof.
(6) Disengage clips attaching reading lamp socket
to back of assist handle base.
(7) Disconnect reading lamp switch from slot on
back of assist handle base.
(8) Remove assist handle from vehicle.
INSTALLATION
(1) Place assist handle in position on vehicle.
(2) Connect reading lamp switch into slot on back
of assist handle base.
(3) Engage clips attaching reading lamp socket to
back of assist handle base.
(4) Place assist handle in position on roof.
(5) Pull and hold assist handle down.
(6) Install front screw attaching assist handle to
roof.
(7) Install screw behind coat hook attaching assist
handle to roof.
SUN VISOR
REMOVAL
All vehicles with driver and passenger side air
bags must have a colored coded five Bullet point air-
bag warning label applied to the sun visor, verify
label availability and ensure the label is installed.
(1) Remove screw attaching inboard visor retainer
to over head. (Fig. 25).
(2) Remove screws attaching outboard visor pivot
base to roof.
(3) Disconnect visor vanity lamp wire connector, if
equipped.
(4) Remove visor from vehicle.
INSTALLATION
All vehicles with driver and passenger side airbags
must have a colored coded five bullet point airbag
warning label applied to the sun visor, verify label
availability and ensure the label is installed.
(1) Engage visor vanity lamp wire connector, if
equipped.
(2) Place visor in position on header.
(3) Install screws attaching outboard visor pivot
base to over head.
(4) Install screw attaching inboard visor retainer
to over head.
Fig. 24 REAR ASSIST HANDLE AND READING
LAMP
1 - COAT HOOK
2 - ASSIST HANDLE
3 - HEADLINING
Fig. 25 SUN VISOR
1 - VISOR PIVOT BASE
2 - WIRE CONNECT
3 - RETAINER
4 - VISOR
LH
INTERIOR
23 - 73
REAR VIEW MIRROR (Continued)
TRUNK LINING
REMOVAL
(1) Remove rear seat cushion and back.
(2) Remove fasteners at forward edge along wheel-
housing
(3) Remove spare tire board, jack, and tire.
(4) Remove fasteners at back panel and sides.
(5) Remove carpet.
INSTALLATION
(1) Fold carpet and load into position in the trunk.
(2) Install fasteners at back and sides panel.
(3) Install spare tire board, jack, and tire.
(4) Install fasteners at forward edge along wheel-
housing
(5) Install rear seat back and cushion.
UPPER QUARTER TRIM
REMOVAL
(1) Disengage clips attaching upper quarter trim
to inner quarter panel (Fig. 21).
NOTE: Start at top forward area of trim and pull
inboard.
(2) Remove seat cushion.
(3) Remove lower seat belt anchor nut.
(4) Slide seat belt through trim panel.
(5) Remove upper quarter trim from vehicle.
INSTALLATION
(1) Slide belt through trim panel.
(2) Place upper quarter trim in position on vehicle.
(3) Engage clips attaching upper quarter trim to
inner quarter panel.
NOTE: Start at lower attachments first and work up.
(4) Install seat belt anchor nut.
(5) Install seat cushion.
UNDER REAR SHELF
SILENCER
REMOVAL
(1) Remove fasteners attaching silencer to lower
shelf sheet metal (Fig. 26).
(2) Remove silencer from vehicle.
INSTALLATION
(1) Place silencer in position on vehicle (Fig. 26).
(2) Install fasteners attaching silencer to the lower
shelf sheet metal.
Fig. 26 UNDER REAR SHELF SILENCER
1 - UNDER SHELF SILENCER
2 - SHELF PANEL
23 - 74
INTERIOR
LH
WHEELHOUSE SILENCER
REMOVAL
(1) Remove rear seat back (Refer to 23 - BODY/
SEATS/REAR SEAT BACK - REMOVAL).
(2) Remove lower quarter trim (Refer to 23 -
BODY/INTERIOR/LOWER
QUARTER
TRIM
-
REMOVAL).
(3) Remove front trunk push pin and fold trunk
carpet down.
(4) Remove fasteners attaching silencer to wheel
house.
(5) Remove silencer from vehicle (Fig. 27).
INSTALLATION
(1) Place silencer into position on the wheel house
(Fig. 27).
(2) Install fasteners attaching silencer to wheel
house.
(3) Install lower quarter trim (Refer to 23 - BODY/
INTERIOR/LOWER QUARTER TRIM - INSTALLA-
TION).
(4) Install rear seat back (Refer to 23 - BODY/
SEATS/REAR SEAT BACK - INSTALLATION).
Fig. 27 WHEELHOUSE SILENCER
1 - WHEEL HOUSE
2 - REAR SHELF PANEL
3 - WHEEL HOUSE SILENCER
LH
INTERIOR
23 - 75
PAINT
TABLE OF CONTENTS
page
page
PAINT
SPECIFICATIONS - COLOR CODE CHARTS
BASECOAT/CLEARCOAT FINISH
. . . . . . . . . . . . . . . . . . . . . . . . . 76
PAINT CODE
. . . . . . . . . . . . . . . . . . . . . . . . . 77
PAINT SURFACE TOUCH-UP
. . . . . . . . . . . . . . . . . . . . . . . . . 77
FINESSE SANDING/BUFFING & POLISHING
. . . . . . . . . . . . . . . . . . . . . . . . . 77
PAINT
SPECIFICATIONS - COLOR CODE CHARTS
EXTERIOR COLORS
EXTERIOR COLOR
DAIMLERCHRYSLER
CODE
EXTERIOR COLOR
DAIMLERCHRYSLER
CODE
BRIGHT SILVER METALLIC
CLEARCOAT
WS2
INFERNO RED TINTED
PEARLCOAT
WEL
BRILLIANT BLACK
PEARLCOAT
AXR
LIGHT ALMOND PEARL
METALLIC CLEARCOAT
ZKJ
BUTANE BLUE METALLIC
CLEARCOAT
ABE
MIDNIGHT BLUE
PEARLCOAT
BB8
DEEP LAVA RED
PEARLCOAT
ZMQ
ONYX GREEN PEARLCOAT
YJR
GRAPHITE METALLIC
CLEARCOAT
ZDP
STONE WHITE CLEARCOAT
SW1
INTERIOR COLORS
INTERIOR COLOR
DAIMLERCHRYSLER
CODE
INTERIOR COLOR
DAIMLERCHRYSLER
CODE
DARK SLATE GREY
DV
SANDSTONE
T5
DARK SLATE GREY
DV
TAUPE
L5
BASECOAT/CLEARCOAT
FINISH
DESCRIPTION
On most vehicles a two-part paint application
(basecoat/clearcoat) is used. Color paint that is
applied to primer is called basecoat. The clearcoat
protects the basecoat from ultraviolet light and pro-
vides a durable high-gloss finish.
CAUTION: Do not use abrasive chemicals or com-
pounds on painted surfaces. Damage to finish can
result.
Do not use harsh alkaline based cleaning solvents
on painted surfaces. Damage to finish or color can
result.
23 - 76
PAINT
LH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст