SsangYong Korando II (1996-2006 year). Manual — part 77
M161 ENGINE MECHANICAL 1B2 -- 13
DAEWOO MY_2000
27. Remove the exhaust manifold and exhaust pipe.
Installation Notice
Tightening Torque
30 NSm (22 lb-ft)
28. Remove the transmission. Refer to Section 5A, Au-
tomatic Transmission.
29. Install a chain to the bracket of engine, by using a
hoist or crane.
30. Remove the engine mount nuts.
Installation Notice
Tightening Torque
70 NSm (52 lb-ft)
31. Carefully separate the engine assembly from the ve-
hicle.
32. Installation should follow the removal procedure in
the reverse order.
1B2 -- 14 M161 ENGINE MECHANICAL
DAEWOO MY_2000
CRANKCASE VENTILATION SYSTEM
Operation at Idling and Mid- Load
1 HFM Sensor
2 Cylinder Head Cover
3 Oil Spearation Chamber (Full--Load or Over
Mid--Load)
4 Intake Air Duct (Cross Pipe)
5 Vent Line (Full--Load or Over Mid--Load)
6 Throttle Valve
7 Restrictor, Diameter 1.1mm
(Mid--Load at Idling)
8 Intake Manifold
9 Vent Line (Mid--Load at Idling)
10 Air Conditioner Bracket
11 Oil Separation Chamber (Mid--Load at Idling)
12 Crank Chamber
13 Oil Return Pipe
14 Oil Pan
15 Timing Gear Case Cover
16 Crankcase
17 Chain Housing
A Fresh Air
B Blow--by Gas
D Vent Connection
M161 ENGINE MECHANICAL 1B2 -- 15
DAEWOO MY_2000
Operation at Idling and Mid- Load
D
The throttle valve (6) is closed or very partially
opened, and the vacuum pressure in intake manifold
is high.
The blow--by gas and the fresh air that is additionally
supplied through the vent connection (D) in the crank-
case in partial load gets supplied to the combustion
chamber from the crank chamber (12) through the oil
separation chamber (11), air--conditioner bracket
(10), vent line (9), and restrictor (7) mounted to the
cylinder head.
The circulated engine oil returns to the oil pan through
the oil return pipe (13) at the bottom of oil separation
chamber (11).
The fresh air gets supplied to the crank chamber (12)
through the HFM sensor (1), intake air duct (4), vent
line (5), oil separation chamber (3), chain housing
(17), and the timing gear case cover (15).
The additional supply of the fresh air is needed to pre-
vent from forming the residues of the engine oil.
1B2 -- 16 M161 ENGINE MECHANICAL
DAEWOO MY_2000
Operation When Full- Load at Partial Load
1 HFM Sensor
2 Cylinder Head Cover
3 Oil Spearation Chamber (Full--Load or Over
Mid--Load)
4 Intake Air Duct (Cross Pipe)
5 Vent Line (Full--Load or Over Mid--Load)
6 Throttle Valve
7 Restrictor, Diameter 1.1mm
(Mid--Load at Idling)
8 Intake Manifold
9 Vent Line (Mid--Load at Idling)
10 Air Conditioner Bracket
11 Oil Separation Chamber (Mid--Load at Idling)
12 Crank Chamber
13 Oil Return Pipe
14 Oil Pan
15 Timing Gear Case Cover
16 Crankcase
17 Chain Housing
A Fresh Air
C Blow--by Gas
D Vent Connection
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст