SsangYong Korando II (1996-2006 year). Manual — part 76

M161 ENGINE MECHANICAL 1B2 -- 9

DAEWOO MY_2000

7. Loosen the cylinder block drain plug and then drain

the coolant completely.
Installation Notice

Tightening Torque

30 NSm (22 lb-ft)

Notice: Replace the seal before installation of the drain

plug.

8. Remove the cooling fan shroud. Refer to Section

1D2, Engine Cooling.

9. Disconnect the each hose from radiator.

10. Remove the upper mounting bolts of radiator and

then remove the radiator.

1B2 -- 10 M161 ENGINE MECHANICAL

DAEWOO MY_2000

11. Remove the hydraulic pipe of power steering.
Notice: Completely drain the oil.

12. Discharge the refrigerant from A/C system, and dis-

connect the discharge pipe and suction pipe from

the compressor.

13. Remove the fuel feed and return line.
Notice: Before removing the fuel lines, release the pres-

sure in the fuel system.

Installation Notice

Tightening Torque

21 -- 25 NSm (15 -- 18 lb-ft)

14. Disconnect the terminals from the generator.

M161 ENGINE MECHANICAL 1B2 -- 11

DAEWOO MY_2000

15. Disconnect the terminals from starter motor and re-

move the starter motor.

16. Disconnect the engine main harness ground.

17. Disconnect the engine ground wire.

18. Disconnect following sensors connector.

D

HFM sensor.

D

Coolant temperature sensor.

D

Knock sensor.

D

Camshaft and crankshaft sensors.

19. After removing the ignition coil cover, disconnect the

ignition coil connector.

20. Remove the harness cover and disconnect the 4 in-

jection valve connectors. Disconnect the main har-

ness.

1B2 -- 12 M161 ENGINE MECHANICAL

DAEWOO MY_2000

21. Separate the hose toward engine from canister

purge solenoid valve and canister. Refer to Section

1F2, Engine Control.

22. Remove the automatic transmission oil cooler line

retaining bolts from the automatic transmission side

and oil pan side.

23. Remove the automatic transmission oil cooler line

retaining bolts from engine side and oil pan side.

24. Separate the vacuum hose for brake booster.
25. Separate the other vacuum hoses.

26. By rotating the crankshaft from the front of engine,

remove the 6 torque converter mounting bolts from

the engine ring gear plate.
Installation Notice

Tightening Torque

42 NSm (31 lb-ft)