SsangYong Korando II (1996-2006 year). Manual — part 70
1G1 -- 10 M162 ENGINE INTAKE & EXHAUST
DAEWOO MY_2000
Function Description
A pneumatically actuated resonance flap (5) is located
on the intake manifold, and will be opened and closed by
load, which operates resonance flap according to engine
and controlled by ECU and rpm.
1. Resonance flap closed (at idle/partial load : less
than 3,800/rpm)
The switch valve (7) will be adjusted by ECU and res-
onance flap will be closed. By increasing air flow pas-
sage through dividing intaking air flow toward both air
collection housing (8). This leads to a signficant in-
crease in the torque in the lower speed range.
2. Resonance flap open (at full load:over 3,800/rpm)
The switch valve (7) will not be adjusted by ECU and
resonance flap (5) will be open. The colllected air in
the air collection housing (8) will not be divided and
intaking air passage will be shorten.
M162 ENGINE INTAKE & EXHAUST 1G1 -- 11
DAEWOO MY_2000
EXHAUST MANIFOLD
Preceding Work: Removal of air cleaner
1 Nut
36--44 NSm (27--33 lb-ft)
. . . . . . . . . . . . . . . . .
2 Gasket
Replace
. . . . . . . . . . . . . . . . . . . . . . . . . . .
3 Exhaust Manifold
1G1 -- 12 M162 ENGINE INTAKE & EXHAUST
DAEWOO MY_2000
Removal & Installation Procedure
1. Remove the flange bolt from the exhaust manifold,
and disconnect the front exhaust pipe.
Installation Notice
Tightening Torque
30 NSm (22 lb-ft)
Notice: Check for nut damages and replace the nut if
necessary.
2. Remove the 23 nuts (1) from the stud bolt, and re-
move the exhaust manifold.
Installation Notice
Tightening Torque
36 -- 44 NSm (27 -- 33 lb-ft)
3. Replace the gasket (2).
4. Installation is reverse order of the removal.
M162 ENGINE INTAKE & EXHAUST 1G1 -- 13
DAEWOO MY_2000
Removal and Installation of Exhaust System
1 Exhaust Pipe
2 Oxygen Sensor
3 Gasket
4 Catalytic Converter
5 Front Muffler
6 Rear Muffler
7 Exhaust Pipe--to--Catalytic Converter
Flange Nuts
28--47 NSm (21--35 lb-ft)
. . . . . . .
8 Front Muffler Pipe--to--Catalytic Converter
Flange Nuts
28--47 NSm (21--35 lb-ft)
. . . . . . .
9 Rear Muffler Pipe Flange--to--Front Muffler
Pipe Flange Nuts
28--47 NSm (21--35 lb-ft)
. . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст