SsangYong Korando II (1996-2006 year). Manual — part 68
1G1 -- 2 M162 ENGINE INTAKE & EXHAUST
DAEWOO MY_2000
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Application
NSm
Lb-Ft
Lb-In
Air Cleaner Mounting Bolt
22.5 -- 27.5
16.6 -- 20.3
--
Exhaust Flange Bolt
30
22
--
Exhaust Manifold Nuts
36 -- 44
27 -- 33
--
Exhaust Pipe--To--Catalytic Converter Flange Nuts
28 -- 47
21 -- 35
--
Front Muffler Pipe--To--Catalytic Converter Flange Nuts
28 -- 47
21 -- 35
--
Lower Intake Manifold Mounting Bolt
22.5 -- 27.5
16.6 -- 20.3
--
Rear Muffler Pipe Flange--To--Front Muffler Pipe Flange
Nuts
28 -- 47
21 -- 35
--
Resonance Flap Retaining Bolts
9 -- 11
--
80 -- 97
Upper Intake Manifold Mounting Bolt
22.5 -- 27.5
16.6 -- 20.3
--
M162 ENGINE INTAKE & EXHAUST 1G1 -- 3
DAEWOO MY_2000
MAINTENANCE AND REPAIR
ON--VEHICLE SERVICE
AIR CLEANER
1 Element Assembly
2 Cleaner Assembly--Air
3 Shield Cover--Air Intake
4 Shield Assembly--Air Intake
5 Braket Assembly--Air Cleaner Mounting
6 Braket Assembly--Shield Surport
1G1 -- 4 M162 ENGINE INTAKE & EXHAUST
DAEWOO MY_2000
Removal and Installation Procedure
1. Disconnect the HFM sensor and the air cleaner by
prying up the clamp.
2. Remove the air cleaner mounting bolt.
Installation Notice
Tightening Torque
22.5 -- 27.5 NSm
(16.6 -- 20.3 lb-ft)
3. Remove air intake shield upper cover, and then re-
move the air cleaner from rubber bearing on bracket.
Notice: For installation, exactly seat the air cleaner into
the rubber bearing.
4. Installation should follow the removal procedure in
the reverse order.
M162 ENGINE INTAKE & EXHAUST 1G1 -- 5
DAEWOO MY_2000
INTAKE AIR DUCT
1 Clamp
2 Sleeve
3 Nut
4 Clamp
5 Intake Air Duct
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст