SsangYong Korando II (1996-2006 year). Manual — part 30
1B1 -- 92 M162 ENGINE MECHANICAL
DAEWOO MY_2000
OIL FILTER
Preceding Work: Removal of starter motor
Removal of upper intake manifold
1 Coolant Line
2 O--ring
Replace
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
3 Clip
4 Hose
5 Bolt
25 NSm (18 lb-ft)
. . . . . . . . . . . . . . . . . . . . . .
6 Oil Filter
7 Gasket
Replace
. . . . . . . . . . . . . . . . . . . . . . . . . . .
M162 ENGINE MECHANICAL 1B1 -- 93
DAEWOO MY_2000
Removal & Installation Procedure
1. Drain the coolant from the crank case.
2. Remove the each coolant line and hose.
3. Remove the oil filter bolt and then remove the oil filter.
Installation Notice
Tightening Torque
25 NSm (18 lb-ft)
Notice: Replace the oil filter gasket.
4. Installation should follow the removal procedure in
the reverse order.
5. Check engine oil level.
6. Run the engine at idle and check the engine for leaks.
1B1 -- 94 M162 ENGINE MECHANICAL
DAEWOO MY_2000
OIL PUMP
Preceding Work: Removal of oil pan
1 Bolt (M8 x 20, 1 piece)
29--35 NSm (21--26 lb-ft)
. . . . . . . . . . . . . . . . . . . .
2 Sprocket (Oil Pump Drive)
3 Bolt (M8 x 35, 3 pieces)
22.5--27.5 NSm (16.6--20.3 lb-ft)
. . . . . . . . . . . . .
4 Spring Pin
5 Oil Pump
M162 ENGINE MECHANICAL 1B1 -- 95
DAEWOO MY_2000
Removal & Installation Procedure
1. Remove the bolt (1) from the oil pump drive sprocket
(2) and separate the gear and the oil pump drive
chain.
Installation Notice
Tightening Torque
29 -- 35 NSm (21 -- 26 lb-ft)
2. Unscrew the oil pump mounting bolts (3).
Installation Notice
Tightening Torque
22.5 -- 27.5 NSm
(16.6 -- 20.3 lb-ft)
Tighten the baffle plate and the oil pump with the two
bolts in right side first, and then tighten the other bolt.
3. Remove the oil pump and oil strainer assembly.
4. Replace the strainer in oil pump if necessary.
5. Installation should follow the removal procedure in
the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст