SsangYong Korando II (1996-2006 year). Manual — part 176
OM600 ENGINE MECHANICAL 1B3 -- 153
DAEWOO MY_2000
Tools Required
115 589 02 34 00 Sliding Hammer
116 589 20 33 00 Threaded Pin
Removal Procedure
1. Removal the cylinder head cover.
2. Pull off the tensioning lever (7) and remove from the
spring (15).
3. Pry off the closing cover (14) and remove the bolt
(13) and then remove the guide pulley (12).
4. Place alignment marks (arrow) on the timing chain
(16) and camshaft sprocket (4).
5. Remove the camshaft sprocket.
1B3 -- 154 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
6. Pull out the bearing pins (9, 11) with sliding hammer
and remove the guide rail 10.
Sliding Hammer 116 589 20 33 00
Threaded Pin 116 589 02 34 00
Installation Procedure
1. Apply collar of both bearing pins with sealing com-
pound.
2. Position the guide rail and insert the bearing pins.
3. Install the camshaft sprocket.
Tightening Torque
10 N∙m (89 lb-in)
Notice
If the max. length ’L’ of the 12--sided bolt exceeds
53.6mm, replace it.
4. Position the no. 1 cylinder at the TDC of OT.
OM600 ENGINE MECHANICAL 1B3 -- 155
DAEWOO MY_2000
In this position, the marking on the camshaft / cam-
shaft bearing cap (arrow) must also be aligned.
5. Install the guide pulley (12).
Tightening Torque
23 N∙m (17 lb-ft)
6. Attach the tensioning lever (7) to the spring (15) and
install.
7. Replace the gasket and install the cylinder head
cover.
Tightening Torque
10 N∙m (89 lb-in)
1B3 -- 156 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
TIMING CASE COVER GUIDE RAIL
Preceding Work : Removal of cylinder head cover
1 Bearing Pin
2 Bearing Pin
3 Guide Rail
4 Oil Pump Chain
5 Crankshaft
6 Spring
7 Bushing
8 Tensioning Lever
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст