SsangYong Korando II (1996-2006 year). Manual — part 175
OM600 ENGINE MECHANICAL 1B3 -- 149
DAEWOO MY_2000
7. Insert the new chain link (1) to connect the chain.
8. Insert the new outer plate (4) into the fitting tool (8)
and then the outer plate will be held by a magnet.
Chain Assembling Device 000 589 58 43 00
9. Place the fitting tool (8) onto the chain link and press
the outer plate on as far as the stop.
10. Switch over the die (9) of the fitting tool (8).
1B3 -- 150 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
11. Place the fitting tool (8) onto the chain link and rivet
the chain pins one by one.
Tightening Torque
35--40 N∙m (26--30 lb-ft)
12. Check the riveting of chain pins and re--rivet if nec-
essary.
13. Remove the wire.
14. Position the no.1 cylinder at TDC.
In this position, the marking on camshaft / camshaft
bearing cap (arrow) must also be aligned. If the
markings are not aligned, the timing chain must be
re--set and the injection pump timing has to be set.
OM600 ENGINE MECHANICAL 1B3 -- 151
DAEWOO MY_2000
TENSIONING RAIL
Preceding Work : Removal of cylinder head
Removal of timing case cover
1 Tensioning Rail
2 Bearing Pin
Notice
The plastic coating of the tensioning rail can not be
replaced.
1B3 -- 152 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
CYLINDER HEAD GUIDE RAIL
Preceding Work : Removal of the cooling fan
Removal of poly V--belt
Removal of chain tensioner
1 Cylinder Head Cover
2 Bolt
10N∙m (89 lb-in)
. . . . . . . . . . . . . . . . . . . . .
3 Gasket
Replace
. . . . . . . . . . . . . . . . . . . . . . . . . .
4 Camshaft Sprocket
5 Washer
6 12--Sided Bolt (M11)
Inspect, 25N∙m (18 lb-ft)+90_
. . . . . . . . . . . . . .
7 Tensioning Lever
8 Bolt
23N∙m (17 lb-ft)
. . . . . . . . . . . . . . . . . . . . . .
9 Bearing Pin
Sealing Compound
. . . . . . . . . . . . .
10 Guide Rail
11 Bearing Pin
12 Guide Pulley
13 Socket Bolt
23N∙m (17 lb-ft)
. . . . . . . . . . . . . . . .
14 Closing Cover
15 Spring
16 Timing Chain
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст