SsangYong Korando II (1996-2006 year). Manual — part 177
OM600 ENGINE MECHANICAL 1B3 -- 157
DAEWOO MY_2000
Removal Procedure
1. Pull out the tensioning lever (8) together with the
spring (6) and guide rail (3) far enough until the ten-
sioning lever has moved passed the oil pump chain
(4) and is resting against the crankshaft (5)
2. Pull the tensioning lever (8) off the bearing pin (2)
and carefully remove the spring (6). Remove the
tensioning lever (8) together with the spring (6) and
bushing (7).
3. Remove the guide rail (3).
Installation Procedure
1. Install the guide rail (3). Attach the spring (6) to the
guide rail and to the tensioning lever (8).
Notice
Ensure that the spring is correctly located in the
guide rail (arrow).
2. Push the guide rail, spring, bushing and tensioning
lever together onto the bearing pin (1, 2).
1B3 -- 158 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
CRANKSHAFT SPROCKET
Preceding Work : Removal of oil pan
Removal of timing case cover
1 12--Sided Stretch Bolt (M11)
Check, 25N∙m (18 lb-ft)+90_
. . . . . . . . . . . . . . .
2 Washer
3 Camshaft Sprocket
4 Timing Chain
5 Bearing Pin
6 Bearing Pin
7 Oil Pump
8 Oil Pump Sprocket
9 Oil Pump Chain
10 Washer
11 Bolt
25N∙m (18 lb-ft)
. . . . . . . . . . . . . . . . . . . . . .
12 Crankshaft Sprocket
13 Crankshaft
15 Key
16 Guide Rail
17 Spring
18 Bushing
19 Tensioning Lever
OM600 ENGINE MECHANICAL 1B3 -- 159
DAEWOO MY_2000
Special Tools
116 589 07 15 00 Drift
102 589 05 33 00 Puller
Removal Procedure
1. Pull out the tensioning lever (19) together with the
spring (17) and guide rail (16) far enough until the
tensioning lever has passed the oil pump chain (9)
and is resting against the crankshaft (13).
2. Pull out tensioning lever (19), spring (17) and bush-
ing (18) from the bearing pin (6).
3. Pull out the guide rail (16).
4. Remove the bolt(11) and then remove the washer
(10), oil pump chin (9) and sprocket (8).
1B3 -- 160 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
5. Place alignment marks (arrow) on the timing chain
(4) and crankshaft sprocket (12).
6. Remove the woodruff key(15).
7. Place alignment marks (arrow) on the timing chain
(4) and camshaft sprocket (3).
8. Remove the chain tensioner.
9. Remove the bolt (1) and then remove the washer (2)
and camshaft sprocket (3).
10. Remove the crankshaft sprocket (12) by using a
puller (20).
Puller 102 589 05 33 00
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст