SsangYong Korando II (1996-2006 year). Manual — part 158
OM600 ENGINE MECHANICAL 1B3 -- 81
DAEWOO MY_2000
Notice
The sealing lip of the repair radial seal is offset to the
inside by 2mm to ensure that is does not run in any
groove which the standard radial seal may have left
on the crankshaft flange.
A Standard Radial Seal
B Repair Radial Seal
Replacement Procedure
1. Pull out the radial seal (1) and be careful not to dam-
age the sealing surface of timing case cover.
2. Thoroughly clean the mounting bore of the radial
seal.
3. Coat a little oil on the sealing lip of new radial (1) and
contact surface.
Notice
Don’t use grease.
4. Install the radial seal (1) by using a sleeve (4).
Notice
Align the groove of sleeve and woodruff key(arrow).
Sleeve 601 589 03 14 00
1B3 -- 82 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
CRANKSHAFT BALL BEARING
1 Spacer
2 Cover
Replace
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
3 Ball Bearing
4 Bolt
45N∙m (33 lb-ft)+ 90_
. . . . . . . . . . . . . . . .
Notice
Manual transmission only.
Tools Required
000 589 33 33 00 Counter Support
000 589 25 33 00 Internal Extractor
Removal & Installation Procedure
1. Remove the manual transmission.
2. Using a puller, pull out the locking ring and ball bear-
ing together.
Counter Support 000 589 33 33 00
Internal Extractor 000 589 25 33 00
3. Apply Loctite 241 on the new ball bearing and then
insert the ball bearing to be stopped at the spacer
ring by using a proper mandrel.
OM600 ENGINE MECHANICAL 1B3 -- 83
DAEWOO MY_2000
CRANKSHAFT
Preceding Work : Removal of the end cover
Removal of the piston
Removal of the crankshaft sprocket
3 Crankshaft Main Bearing Shells (Upper)
4 Trust Bearings (Upper)
5 Crankshaft
6 Crankshaft Main Bearing Shells (Lower)
7 Thrust Bearings (Lower)
8 Crankshaft Bearing Cap
9 Crankshaft Bearing Cap (Fit Bearing)
10 12--sided Stretch Bolts : 55N∙m (41 lb-ft)+90_
Tools Required
001 589 53 21 00 Dial Gauge
363 589 02 21 00 Dial Gauge Holder
366 589 00 21 05 Extension
1B3 -- 84 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
Thrust Washer and Bearing Arrangement
OM662LA Engine
3 Crankshaft Main Bearing Shells (Upper)
4 Thrust Bearings (Upper)
5 Crankshaft
6 Crankshaft Main Bearing Shells (Lower)
7 Thrust Bearings (Lower)
A Radial Bearings
B Radial and Axial Bearings (Thrust Bearing)
Notice
The gaps between the bearing shell and bore and
between the bearing shell and journal are different
each other. Refer to service data.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст