SsangYong Korando II (1996-2006 year). Manual — part 154
OM600 ENGINE MECHANICAL 1B3 -- 65
DAEWOO MY_2000
9. Disconnect the pipes of power steering pump and
remove the belt pulley.
Notice
Be careful not to lose the key.
10. Remove the nut and pull out the bolt and then re-
move the power steering pump.
11. Remove the generator bracket (16).
12. Remove the fuel filter.
1B3 -- 66 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
13. Remove the camshaft.
14. Remove the socket bolts(4) in the chain box.
Socket Wrench 115 589 03 07 00
15. Remove the injection pump.
Notice
See the “Removal of fuel injection pump”.
16. Remove the oil pan bolts (8, 9) in the area of the tim-
ing case cover (14).
17. Slightly loosen the remaining oil pan bolts.
18. Remove the timing case cover (19) bolts and then
remove the timing case cover (14).
Notice
Be careful not to damage the cylinder head gasket
or oil pan gasket.
OM600 ENGINE MECHANICAL 1B3 -- 67
DAEWOO MY_2000
Installation Procedure
1. Thoroughly clean the sealing surface and apply
sealant.
2. Install the timing case cover.
Tightening Torque
10 N∙m (89 lb-in)
Notice
Bolts arrangement
1.M6 x 60
2.M6 x 70
3.M6 x 40
3. Tighten the socket bolts in the chain box.
Tightening Torque
23 N∙m (17 lb-ft)
4. Tighten the oil pan bolts.
Ti h
i
Socket bolt
10 N∙m (89 lb-in)
Tightening
Torque
M6 bolt
10 N∙m (89 lb-in)
Torque
M8 bolt
23 N∙m (17 lb-ft)
1B3 -- 68 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
5. Install the flange, vibration damper and crankshaft
belt pulley.
Notice
Replace front radial seal if necessary.
6. Install the generator bracket.
Tightening
Front
25 N∙m (18 lb-ft)
Tightening
Torque
Side
25 N∙m (18 lb-ft)
7. Install the generator.
Tightening Torque
Upper -- 25 N∙m (18 lb-ft)
Tightening Torque
Low -- 25 N∙m (18 lb-ft)
8. Install the cylinder head cover.
Tightening Torque
10 N∙m (89 lb-in)
9. Tighten the injection pump mounting bolts.
Tightening Torque
23 N∙m (17 lb-ft)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст