SsangYong Korando II (1996-2006 year). Manual — part 227
SSANGYONG MY2002
3D-12 REAR AXLE
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
;;;;;;;
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
yyyyyyy
7. Remove the axle shaft.
KAA3D200
KAA3D210
KAA3D230
KAA3D220
Tightening Torque
50 - 65 N•m
(37 - 48 lb-ft)
Installation
1. Check the rear axle shaft.
2. Insert the rear axle shaft into the axle housing and
tighten the fixing nuts of axle shaft flange.
Installation Notice
3. Connect the brake cable and install the brake
drum.
4. Install the tire and test the braking force.
REAR AXLE 3D-13
SSANGYONG MY2002
REAR AXLE HOUSING
Removal
1. Remove the tire.
2. Remove the connecting rod of LCRV assembly &
fixing nut of axle housing bracket.
KAA3D240
KAA3A250
KAA3D260
KAA3D270
3. Disconnect the brake oil hose & oil line (pipe)
•
Brake pipe nut.
•
Brake pipe mounting clip
•
3-way connector
•
Brake pipe assembly
4. Detach the air breather.
5. Remove the propeller shaft from rear axle input
shaft.
Notice: Do alignment marks before removing.
SSANGYONG MY2002
3D-14 REAR AXLE
KAA3D280
KAA3D300
KAA3D290
6. Pull out the fixing pin of parking brake.
7. After removing the parking brake lever, pull out
the cable.
KAA3D310
8. Remove the lower arm mounting nuts and remove
the lower arm from the axle housing.
9. Detach the lower mounting of shock absorber from
the axle housing.
10. Remove the upper arm mounting nuts and remove
the upper arm from the axle housing.
REAR AXLE 3D-15
SSANGYONG MY2002
11. Remove the stabilizer bar.
KAA3D320
KAA3D330
KAA3A350
KAA3A340
12. Remove the lateral rod mounting nut and detach
the lateral rod from the axle housing.
13. Lowering the axle slowly, remove the coil spring
& spring seat.
14. Lower the axle housing by using the safety jack.
Installation
1. Placing the rear axle housing on the assembly
position, install both coil springs.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст