SsangYong Korando II (1996-2006 year). Manual — part 83
M161 ENGINE MECHANICAL 1B2 -- 37
DAEWOO MY_2000
CRANKSHAFT SEALING REAR COVER
Preceding Work: Removal of the automatic transmission drive plate or flywheel
1 Bolt (M6 x 20, 6 pieces)
9--11 NSm (80--97 lb-in)
. . . . . . . . . . . . . . . . . . . . .
2 Radial Shaft Seal
3 Rear Cover
4 Sleeve
5 Bolt (M6 x 85, 2 pieces)
9--11 NSm (80--97 lb-in)
. . . . . . . . . . . . . . . . . . . . .
6 Washer
1B2 -- 38 M161 ENGINE MECHANICAL
DAEWOO MY_2000
Tools Required
601 589 03 43 00 Crankshaft Rear Seal Installer
Removal & Installation Procedure
1. Unscrew the bolts (1) and (5) and remove the closing
cover by pulling the rear cover lug (arrows).
Notice: Be careful not to damage the oil pan gasket.
2. Clean the sealing surface of the crankcase and the
rear sealing cover.
3. Check the radial shaft seal and replace it if necessary.
4. Apply the Loctite 573 to the rear cover sealing sur-
face.
5. Apply the engine oil to the dust lip of the radial shaft
seal.
Notice: Do not use the grease.
6. Install the crankshaft rear radial seal and the crank-
shaft sealing rear cover, using crankshaft rear seal in-
staller 601 589 03 43 00.
7. Install the crankshaft sealing rear cover mounting
bolts and remove the crankshaft rear seal installer
601 589 03 43 00.
Installation Notice
Tightening Torque
9 -- 11 NSm (80 -- 97 lb-in)
8. Installation should follow the removal procedure in
the reverse order.
M161 ENGINE MECHANICAL 1B2 -- 39
DAEWOO MY_2000
BELT PULLEY AND VIBRATION DAMPER
Preceding Work: Removal of cooling fan and viscous clutch
Removal of fan shroud
Removal of drive belt
1 Vibration Damper Center
1st step 200+20 NSm (148+15 lb-ft)
. . . . . . . . .
2nd step 90°+10° rotation added
2 Vibration Damper Disk
5 Vibration Damper Assembly
6 Key
1B2 -- 40 M161 ENGINE MECHANICAL
DAEWOO MY_2000
Components
1 Center Bolt (M18 x 50)
2 Center Bolt Washer
3 Vibration Damper and Pulley Assembly
4 Key
5 Crankshaft Front Seal
6 Timing Gear Case Cover
7 Crankshaft Sprocket (Camshaft Driven)
8 Crankshaft Sprocket (Oil pump Driven)
9 Crankshaft
10 Oil Pan
11 Oil Pan Gasket
12 Oil Pan Mounting Bolt (M6 x 22)
Service Data Standard
Permissble Deviation of The Vibration Damper
Radial Runout
0.6 mm
p
Axial Runout
0.6 mm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст