SsangYong Musso. Manual — part 228
FRONT SUSPENSION 2C-13
VERTICAL AND LATERAL SENSOR
Removal & Installation Procedure
1. Disconnect vertical sensor and lateral sensor connectors.
Notice
When connecting the connectors, connector connection of
the lateral sensor (2) should be in the right and connector
connection of the vertical sensor (1) should face downward.
2. Unscrew bolts and remove vertical sensor and lateral sensor.
Installation Notice
1
Body Vertical Acceleration Sensor(Vertical Sensor)
2
Body Lateral Acceleration Sensor (Lateral Sensor)
3. Installation should follow the removal procedure in the
reverse order.
Tightening Torque
20 - 30 Nm
2C-14 FRONT SUSPENSION
ECS (ECU)
1 Electronically Controlled Suspension (ECU)
2 Connector
3 Bolts (2 pieces)
Removal & Installation Procedure
1. Disconnect each connectors from the console box and
remove the console box.
2. Disconnect ECU connector.
3. Unscrew 10mm x 2 bolts and remove ECS (ECU).
4. Installation should follow the removal procedure in the
reverse order.
4 Parking Brake Lever
5 Over Voltage Protection Relay
Type
Spring Type
Coil Spring
Shock Absorber
Stabilizer Type
Description
5-link
Coil Spring
13.8 mm
126.8 mm
384.5 mm
φ
139.6 mm
2.58 kg
Cylindrical Reciprocation Type
Torsion Bar Type
SECTION 2D
REAR SUSPENSION
TABLE OF CONTENTS
SPECIFICATIONS
GENERAL SPECIFICATIONS
Wire Diameter (mm)
Diameter (mm)
Free Heigth (mm)
Outer Diameter (mm)
Spring Constant (kg
•
m)
Application
Specifications . . . . . . . . . . . . . . . . . . . . . . . . 2D-1
General Specifications . . . . . . . . . . . . . . . . . . 2D-1
Fastener Tightening Specifications . . . . . . . . . 2D-1
Diagnosis . . . . . . . . . . . . . . . . . . . . . . . . . . . 2D-2
Noise (During Straight Driving) . . . . . . . . . . . . 2D-2
Oil Leakage . . . . . . . . . . . . . . . . . . . . . . . . . . 2D-2
Noise (During Turning) . . . . . . . . . . . . . . . . . . 2D-2
Heating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2D-3
Component Locator . . . . . . . . . . . . . . . . . . . 2D-4
Maintenance and Repair . . . . . . . . . . . . . . . 2D-5
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . 2D-5
Rear Suspension(5-Link) . . . . . . . . . . . . . . . . 2D-5
Rear Shock Absorber . . . . . . . . . . . . . . . . . . . 2D-9
FASTENER TIGHTENING SPECIFICATIONS
Application
Upper Nut
Stabilizer Bar Bolt
Lateral Rod Nut
Shock Absorber Mounting Nut Upper
Arm Fixing Nut
N
!
!
!
!
!
m
16 - 22
30 - 45
150 - 180
50 - 65
150 - 180
2D-2 REAR SUSPENSION
DIAGNOSIS
NOISE (DURING STRAIGHT DRIVING)
Check
Lack of Oil
Low Viscosity of Oil
Insufficient Oil
Excessive Backlash of Ring Gear
Worn or Damaged Tooth of Ring and Pinion Gear
Worn or Damaged Drive Pinion Bearing
Worn Spline of Side Bearing and Side Gear
Bent Axle Housing
Bent Differential Case
Worn Pinion Shaft
Incorrect Drive Pinion Preload
Incorrect Contact of Ring Gear and Pinion
Action
Replenish
Replace
Replace
Adjust
Replace
Replace
Replace
Replace
Replace
Replace
Adjust
Retightening
NOISE (DURING TURNING)
Check
Worn or Damaged Tooth of Pinion or Side Gear
Worn Pinion Shaft
Excessive Backlash of Pinion Gear and Side Gear
Excessive End-play of Rear Axle Shaft
Incorrect Contact of Side Gear and Differential Case
Axle Housing Crack
Bent or Poor Installation of Drive Pinion Oil Seal
Damaged or Torn Drive Pinion Oil Seal
Loosened Bearing Collar
Worn or Damaged Universal Joint
Worn of Damaged Axle Shaft Bearing
Action
Replace
Replace
Replace
Adjust
Replace
Replace
Replace
Replace
Replace
Replace
Replace
OIL LEAKAGE
Check
Excessive Oil
Faulty Seal of Carrier Contact Surface
Axle Housing Crack
Worn or Damaged Oil Seal
Action
Adjust
Repair
Replace
Replace
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст