SsangYong Musso. Manual — part 346
M161 ENGINE CONTROLS 1F2-63
4. Remove the line to canister and measure the pressure with
the vacuum pressure gauge.
Test
1. Maintain the normal temperature and idling state by
operating the engine.
2. Connect the ECU terminal No.11 and No.34 and check for
normal operation through the output waves using the
scanner.
Notice
Test during purge control switchover valve operation after
the minimum of 1 minute after the engine turned on.
3. Connect the ECU terminal No.34 and No.10 and check for
current consumption during the ignition switch ON.
Purge switchover valve output wave
Specified Value
0.3 - 0.5
Specified Value
> 50mbar
(after approx. 1min.)
purge switchover valve
operates at this time
Notice
Test while at normal temperature and at idling state by
operating the engine.
1F2-64 M161 ENGINE CONTROLS
1 Purge Switchover Valve
2 Molded Hose
3 Fuel Tube (270 mm)
4 Clamp
5 Molded Hose
6 Intake Manifold
7 Throttle Body
VACUUM SYSTEM
Manual Transmission
8 Fuel Pressure Regulator
9 Vacuum Line Rubber Hose (40 mm)
10 Vacuum Tube (Gray, 540 mm)
11 Rubber Cap
12 Molded Hose
13 Vacuum Tube (Brown)
14 Connector
M161 ENGINE CONTROLS 1F2-65
15 Manual Transmission
16 Distributor
Automatic Transmission
A. To Canister
B. To Auto Locking Hub
1F2-66 M161 ENGINE CONTROLS
1 Crankshaft Position Sensor (connector)
2 Bolt (M6 X 14) . . . . . . . . . . 9-11 Nm
CRANKSHAFT POSITION SENSOR
Removal & Installation Procedure
1. Disconnect the wiring connector at the crankshaft position
sensor.
2. Unscrew the bolt (2) and remove the crankshaft position
sensor unit (3).
Installation Notice
3. Installation should follow the removal procedure in the
reverse order.
3 Sensor Unit
Tightening Torque
9 - 11 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст