SsangYong Musso. Manual — part 426
OM600 ENGINE INTAKE & EXHAUST 1G3-3
AIR CLEANER AND INLET DUCT & HOSE
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
1
Air Intake Shield Assembly
2
Air Cleaner Assembly
3
Mounting Bracket
4
Air Cleaner Element . . ... Clean : 20,000km
Replace : 60,000km
5 Bolt . . . . . . . . . . . . . . . 9-11Nm
6 House
7 Clamp
8 Engine Cover Assembly (Turbo)
9 Mounting Bracket
1G3-4 OM600 ENGINE INTAKE & EXHAUST
Removal & Installation Procedure
1. Loosen the air duct hose clamp and then remove the air
cleaner and air duct hose.
2. Disconnect the air cleaner housing cover clamp and remove
the cover and element.
Tightening Torque
9 - 11 Nm
3. Loosen the nut (4EA) and remove the air cleaner housing
from the intake manifold.
Notice
Do not fold the rubber.
Operating Interval
Clean
Replace
every 20,000km
every 60,000km
4. Loosen the clamp and remove the air duct hose.
5. Loosen the mounting nut and bolt.
6. Remove the air inlet duct and hose.
7. Installation should follow the removal procedure in the
reverse order.
OM600 ENGINE INTAKE & EXHAUST 1G3-5
INTAKE AND EXHAUST MANIFOLD
1 Nut . . . . . . . . . . . . . 22.5-27.5 Nm
2 Washer
3 Support Assembly Bar
4 Nut . . . . . . . . . . . . . 22.5-27.5 Nm
5 Exhaust Manifold Assembly
6 Exhaust Gasket
7 Stud Bolt . . . . . . . . . . .. 9.9-12.1 Nm
8 Bolt (M8) . . . . . . . . . . 22.5-27.5 Nm
9 Intake Duct
10 Intake Duct Gasket
11 Intake Manifold
12 Intake Gasket
1G3-6 OM600 ENGINE INTAKE & EXHAUST
Exhaust Line
1 Heat Protector Assembly
2 Heat Protector Floor
3 Exhaust Front Pipe Assembly
4 Ring
5 Exhaust Rear Pipe Assembly
6 Muffler
7 Mounting
8 Heat Protector Front Floor
9 Tail Exhaust Pipe Assembly
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст