SsangYong Stavic / SsangYong Rodius (2005 year). Manual — part 19
1B-55
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
Notice
If out of specification, replace the piston ring.
Replacement Procedure
1. Measure the piston ring’s gap.
2. Remove the piston ring with a pliers.
3. For installation, position the piston ring to be the ‘TOP’
mark on the piston ring upward and arrange the piston
ring ends to be 120° apart.
4. Adjust the hook spring joint in the oil ring 180° away
from the ring end.
Gap between the
Piston and the
Piston Ring
Groove 1 0.20 ~ 0.40 mm
Groove 2 0.20 ~ 0.40 mm
Groove 3 0.20 ~ 0.45 mm
Groove 1 0.015 ~ 0.050 mm
Groove 2 0.020 ~ 0.040 mm
Groove 3 0.010 ~ 0.045 mm
End Gap of the
Piston Ring
1B-56
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
FLYWHEEL/DRIVEN PLATE
Preceding Work: Removal of manual or automatic transmission
1. Flywheel mounting bolt (M10 x 22, 8 pieces)
. . . . . . 1st step: 45 + 5 Nm (33 + 3.7 lb-ft)
2nd step: 90° + 10°
2. Plate
3. Driven plate (A/T)
4. Dowel pin
Service Data Standard (Stretch Bolt)
Nominal size
Stretch side diameter
Bolt length
Tightening torque
M x 1.5
8.5 ~ 0.2 mm
8.0 mm
21.8 ~ 22.2 mm
-
When new
Min. diameter
When new
D
d
L
1st step: 45 + 5 Nm (33 + 3.7 lb-ft),
2nd step: 90° + 10°
1B-57
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
Removal & Installation Procedure
1. Unscrew the driven plate mounting bolt.
Installation Notice
• Replace the bolt when the stretch side diameter (d)
of the driven plate mounting bolt is less than 8.0 mm.
• For the stretch bolt tightening, keep the socket
wrench and Tommy-bar to be 90° and tighten as
specified.
2. Remove the driven plate (3), and plate (2) for automatic
transmission vehicle.
3. Installation should follow the removal procedure in the
reverse order.
Tightening torque
1st step: 40 + 5 Nm
(30 + 3.7 lb-ft)
2nd step: 90° + 10°
1B-58
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
Sectional View
1. Oil pan
2. Cover
3. Crankshaft front seal
4. Flywheel mounting bolt
5. Crankshaft
6. Dowel pin
7. Washer (thickness = 3.5 mm)
8. Washer
9. Bolt
10. Front drive plate
11. Rear drive plate
12. Rivet
13. Segment
14. Ring gear
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст