SsangYong Stavic / SsangYong Rodius (2005 year). Manual — part 15
1B-37
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
Components
1. Center bolt (M18 x 50)
2. Vibration damper disk
3. Vibration damper and pulley assembly
4. Woodruff key
5. Crankshaft front seal
6. Timing gear case cover
7. Crankshaft sprocket (camshaft driven)
8. Crankshaft sprocket (oil pump driven)
9. Crankshaft
10. Oil pan
11. Oil pan gasket
12. Oil pan mounting bolt (M6 x 22)
Service Data Standard
Permissble Deviation of The Vibration Damper
Radial Runout
Axial Runout
0.6 mm
0.6 mm
1B-38
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
2. Remove the start motor and install the engine lock A9910
0150B (602 589 00 40 00) to the flywheel ring gear.
3. Remove the vibration damper center bolt.
Installation Notice
4. Remove the vibration damper assembly using the puller.
5. Installation should follow the removal procedure in the
reverse order.
Notice
If possible, don’t separate the vibration damper and
the pulley.
Tools Required
A9910 0150B (602 589 00 40 00)
Engine Lock
Removal & Installation Procedure
1. Adjust the piston of number 1 cylinder to the TDC.
Tightening torque
1st step: 180 ~ 220 Nm
(133 ~ 162 lb-ft)
2nd step: 90° + 10°
1B-39
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
CRANKSHAFT FRONT RADIAL SEAL
Preceding Work: Removal of belt pulley and vibration damper
1. Center bolt (M18 x 50)
. . .. 1st step: 180 ~ 220 Nm (133 ~ 162 lb-ft)
2nd step: 90°+10°
2. Center bolt washer
3. Sleeve (special tool)
4. Crankshaft front seal
5. Key
1B-40
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
Tools Required
A9911 0060B (601 589 03 14 00)
Crankshaft Front Seal Installer
Replacement Procedure
1. Remove the radial seal with a screw driver.
Notice
Use a clean cloth not to damage the radial seal
mounting hole and the crankshaft.
2. Coat the radial sealing lip with engine oil.
3. Using the crankshaft front seal installer A9911 0060B
(601 589 03 14 00), assemble the radial seal.
4. Align the sleeve groove and the woodruff key and tighten
the center bolt until the center bolt and the damper disk
stop in the movement.
Installation Notice
5. Remove the crankshaft front seal installer A9911 0060B
(601 589 03 14 00), and install the belt pulley and the
vibration damper.
6. Check for leaks while operating the engine.
Tightening torque
1st step: 180 ~ 220 Nm
(133 ~ 162 lb-ft)
2nd step: 90° + 10°
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст