SsangYong Stavic / SsangYong Rodius (2005 year). Manual — part 16
1B-41
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
Preceding Work: Removal of flywheel or drive plate
1. Special tool
2. Special tool
3. Crankshaft rear seal
CRANKSHAFT REAR RADIAL SEAL
1B-42
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
Tools Required
W9911 0020B (601 589 03 43 00)
Crankshaft Rear Seal Installer
Replacement Proceudre
1. Remove the radial seal with a screw driver.
Notice
Use a clean cloth not to damage the radial seal
mounting hole and the crankshaft.
2. Install the crankshaft rear seal installer W9911 0020B
(601 589 03 43 00) (2) to the crankshaft.
3. Apply the engine oil on the crankshaft rear seal installer
W9911 0020B (601 589 03 43 00) (2).
Notice
Do not use the grease.
4. Install the radial seal on the inner parts assembler.
5. Press in the crankshaft rear seal installer W9911 0020B
(601 589 03 43 00) (1) until the radial seal is stopped.
6. Check for leaks while operating the engine.
1B-43
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
CRANKSHAFT
Preceding Work: Removal of engine assembly
Removal of timing gear case cover
Removal of cylinder head
Removal of crankshaft sealing rear cover
Removal of oil pan
Removal of oil pump
Removal of baffle plate
1. Crankshaft bearing cap bolt (M8 x 55, 14 pieces)
. . . . ... 1st step: 50 ~ 60 Nm (37 ~ 44 lb-ft)
2nd step: 90° + 5°
2. Crankshaft bearing cap
3. Crankshaft lower main bearing
4. Crankshaft lower thrust bearing
5. Crankshaft
1B-44
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
Arrangement of the Thrust Bearing and the Main Bearing
Weight Balance/Color Marking Point
Journal Main Bearing #1 - #7
Color Dot Marking
A. Crankcase side
B. Bearing cap side (oil pan side)
C. Axial fit bearing (number 5 bearing point)
D. Radial bearing
1. Upper main bearing
2. Upper thrust bearing
3. Crankshaft
4. Lower main bearing
5. Lower thrust bearing
The color dot marking are put on the 1 , 2 , 4 , 6 , 8 , 10 ,
12 and it indicates the diameter of crankshaft journal by
color as below.
1 - 12
j1 - j7
•
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст