SsangYong Stavic / SsangYong Rodius (2005 year). Manual — part 155
DI10-15
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.9
Leak Detection
Preceding Work: Perform the “Entering Diagnosis Pro-
cedures”
Note
This item is for checking the high fuel pressure after the
IMV supply line of HP pump in DI engine fuel system. If
you still suspect that the fuel pressure system is defective
even after no trouble is detected, perform the fuel pressure
test again by using a fuel pressure tool kit.
1. Select “7] LEAK DETECTION” and press “
” in
“FUNCTION SELECTION” screen.
2. The “LEAK DETECTION” screen that shows the checking
conditions as shown in figure is displayed.
DI10-16
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.9
Variant Coding
Preceding Work: Perform the “Entering Diagnosis Pro-
cedures”
1. Select “8] VARIANT CODING” and press “
” in
“FUNCTION SELECTION” screen.
2. When the “VARIANT CODING” screen is displayed,
select “1] READ VARIANT VALUE” and press “
”.
3. The “VARIANT CODING” screen that shows currently
equipped devices is displayed.
DI10-17
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.9
4. If you need to change the variant coding, press “
”
key to go back to “VARIANT CODING” screen. In the
screen, select “2] WRITE VARIANT CODING” and press
“
”.
5. When the “WRITE VARIANT CODING VALUE” screen is
displayed, change the item by using arrow keys.
6. If you press “
”, the message as shown in figure
appears. And, then “VARIANT CODING” screen is
displayed.
7. Select “READ VARIANT VALUE” to see the coding coded
value.
DI10-18
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.9
ECU Replace
Preceding Work: Perform the “Entering Diagnosis Pro-
cedures”
1. Select “0] ECU REPLACE” and press “
” in
“FUNCTION SELECTION” screen.
3. When the “ECU REPLACE (STEP 2)” screen is displayed
followed by “ECU REPLACE (STEP 1) screen, turn the
ignition “OFF” and remove the currently installed ECU.
Notice
Do not turn off the Scan-100 at this time.
Record the below data:
- Vehicle identification number
- Variant coding value
- C2I coding value
- Multi calibration
4. Install the new ECU.
2. Before starting ECU replace, check the ECU S/W version
of old ECU and new ECU.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст