SsangYong Rodius (2013 year). Manual — part 150
04-4
Rear axle assembly
Mounting hole position and seat pan angle for rear axle changed due to change of rear sub frame
2. CHANGES
Changes in rear axle assembly
▶
Changes in rear axle shaft assembly
▶
Rear Axle Shaft Assembly
Increased rear axle shaft length (15.0 mm) due to change of rear sub frame
Mounting section
04-5
4120-01
1. OVERVIEW
The axle is the device of transferring the drive power from the engine to the wheels; its inside is fitted to
the side gear spline of the differential gear and outside is connected to the drive wheels. The axles in
front and rear of vehicle are known as the front axle and rear axle respectively.
For the FR (Front engine, Rear wheel drive) type vehicle driven by the rear wheels, the drive power is
basically transferred to the rear wheels in the following order in 2WD mode: Engine-
>Clutch→Transmission→Propeller shaft (Rear propeller shaft)→Final reduction gear (Rear
axle)→Rear axle shaft→Rear wheels. In 4WD mode, the drive power to the rear wheels is
distributed to the front wheels in order of Front propeller shaft->Front axle->Front axle shaft->Front
wheel via the T/C assembly. And, 4WD solenoid valve releases the vacuum and engage the locking
hub actuator to the LH/RH front hub end gear to transfer the drive power of the axle shaft to the front
wheels.
The front axle and front axle shaft are used in only 4WD model. The rear axle has the independent
rear drive axle (IRDA) which is used on the independent rear suspension (IRS).
Front axle
Transmission
Transfer case
Front propeller shaft
Rear propeller shaft
Rear axle
04-6
2. Power Flow
Power Transfer Process in Axle System at 4WD and 2WD Modes
▶
The vehicle is usually driving in 2WD mode but, if the driver operates, the drive power is distributed to
the front wheels rather than rear wheels via the transfer case only in 4WD mode in following order:
Front propeller shaft->Front axle->Front axle shaft->Front wheel.
Refer to "CHASSIS T/C" section for detailed information for 4WD drive.
*
05-3
3240-01
Weight
32.4 kg (including oil)
Oil capacity
1.4 L
Oil type
ATF DEXRON II or III
Location
Transfer case
Major element
Housing
Part-time
Bolt
11EA, M8 x 1.25
Input shaft
A/T: outer spline
Description
Specifications
Total length
343 mm
1. SPECIFICATIONS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст