SsangYong Rexton. Manual — part 676
SSANGYONG Y200
9D-18 BODY ELECTRICAL
YAD9D260
YAD9D270
YAD9D280
Fuel System
Gauge of fuel
1. Separate connector of fuel sender.
2. Ground connector (B11, B14) of direction of
harness through bulb (12 V, 3.4 W).
3. Turn the start switch on.
4. See if bulb of testing turn on, and see if indicator
of fuel gauge gradually move to position of ‘F’.
Check resistence of fuel sender
1. Put float on the position of ‘F’ and ‘E’, and check
resistence between B11 and B14.
2. While float is moving from position of ‘E’ to
position of ‘F’, check if resistence change
gradually.
Position of float
E
1/2
F
Specified resistence
approximately 285
Ω
approximately 101.5
Ω
approximately 40
Ω
Fuel sender
1. Connect testing bulb (12 V. 3.4 W) of fuel gauge
terminal deepen thermister in the water.
2. See if thermister is deepened in the water, light is
off, and see if thermister get out of water, light is
on.
Notice:
•
If malfunction may happen, replace fuel sender
assembly.
•
After this testing have done, before fuel sender
i s i n s t a l l e d , f u e l s e n d e r s h o u l d d r y u p
completely.
Gauge of Temp
1. Separate wiring connector of water coolant in the
engine room.
2. Ground between testing bulb (12 V,3.4 W) and
connector to harness in a series.
3. Turn ignition switch on.
4. See if testing light turns on or not, check if gauge
of water temp operate or not.
BODY ELECTRICAL 9D-19
SSANGYONG Y200
YAD9D290
YAD9D300
YAD9D310
Check resistence of sensor of water temp
After checking resistence between terminal and ground
with gage of resistence, if resistence get out of
specification, replace it by new one.
temp (°C)
resistence(
Ω
)
C (50)
254
C (50)
77
C (50)
42.2
C (50)
27.8
Switch of Oil Pressure
1. After stopping engine, check applying of electric
current between terminal and ground.
2. After driving engine, check applying of electric
current between terminal and ground.
3. Separate connector from terminal of ground and
warning switch to wiring harness.
4. After ignition switch turn to “on” and then check
if the light is on, if the light is not “on” test the
bulb and check harness.
SSANGYONG Y200
9D-20 BODY ELECTRICAL
YAD9D320
YAD9D330
YAD9D340
YAD9D350
Brake
If the switch of starting turns on, the fluid of brake is
under specified level, or while lever of parking brake
is pulling, sensor of brake or switch of parking brake
is “on” and then warning of brake turns on.
Notice: Sensor of brake fluid is installed on the
reservoir tank of master cylinder.
1. Separate gauge connector of brake fluid level.
2. While switch is turned off, check applying of
electric current between terminal.
3. While switch is turned on, check applying of
electric current between terminal.
Switch of parking brake
Switch of parking brake is located under lever of
parking brake, if switch of parking brake is adjusted,
after releasing parking brake, switch of parking brake
is installed .
1. While switch is turned on (lever is pulling), check
applying of electric current between terminal and
switch.
2. While switch is turned off (lever is released), check
applying of electric current between terminal and
switch, applying of electric current get out of
specification, replace switch, or check grounding.
Door Switch
1. Switch of door is removed, check applying of
electric current between terminals.
2. If applying of electric current between terminals
get out of specification, replace switch of door.
REMOVAL AND INSTALLATION OF
INSTRUMENT PANEL
1. Remove negative terminal of battery.
2. After releasing screw (2ea), remove housing of
instrument panel .
BODY ELECTRICAL 9D-21
SSANGYONG Y200
YAD9D360
YAD9D370
YAD9D380
YAD9D390
3. After releasing fixing screw (4ea) of instrument
panel, separate connector (3ea), and then remove
instrument panel.
6. Install reverse order of removal, after installing,
check operation of instrument panel.
5. After separating the glass of instrument, and then
r e l e a s e f i x i n g s c r e w ( 5 e a ) , a n d s e p a r a t e
instrument panel and housing.
4. Separate all the bulb from the instrument removed
like the left picture.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст