SsangYong Rexton. Manual — part 345
M161 ENGINE MECHANICAL 1B2-63
SSANGYONG Y200
VALVE STEM SEAL
Preceding Work: Removal of valve spring
1 Drift 119 589 00 43 00
2 Valve Stem Seal
Tools Required
119 589 00 43 00 Drift
Replacement Procedure
1. Remove the valve stem seal (2) using the pliers.
Notice: Check the valve stem seal for damage
and replace if necessary.
2. Coat the valve stem seal with oil and assemble it
with the protective sleeve.
3. Insert the valve stem seal by pressing it with the
drift 119 589 00 43 00.
YAD1B1K0
3 Protective Sleeve
YAD1B1M0
SSANGYONG Y200
1B2-64 M161 ENGINE MECHANICAL
CHAIN TENSIONER
1 Screw Plug . . . . . . . ... 40 N•m (30 lb-ft)
2 Seal
3 Filler Pin
4 Compression Spring
5 Snap Ring
Removal Procedure
1. Position the number 1 cylinder to ATDC 20 ° .
Notice: Remove the oil filler cap at adjustment
position, and check whether the intake camshaft
cam’s lobe (arrow) stays in the upper side.
2. Cover the generator with a clean cloth.
3. Release the tension by unscrewing the screw plug
once.
Notice: In case that the tension is reduced by
unscrewing the screw plug, reinstall after
completely removing the chain tensioner. If the
chain tensioner is tightened again without
completely reducing its tension, then the snap ring
doesn’t return to the original position and the
tension gets exceeded.
YAD1B1N0
6 Thrust Pin
7 Chain Tensioner Housing
. . . . . . . . .. 72 - 88 N•m (53 - 65 lb-ft)
8 Seal
YAD1B1P0
M161 ENGINE MECHANICAL 1B2-65
SSANGYONG Y200
YAD1B1Q0
YAD1B1R0
YAD1B1S0
4. Carefully unscrew the screw plug (1), and remove
the seal (2).
Notice:
•
For the removal of screw plug, be careful that it
can b e j u m p e d o u t d u e t o t h e f o r c e o f
compression spring.
•
Remove the screw plug only when the seal and
compression spring are damaged.
5. Carefully remove the filler pin (3), compression
spring (4), snap ring (5), and the thrust pin (6).
2. Install the chain tensioner housing (7), thrust pin
(6), snap ring (5), and the seal (8).
Installation Notice
Installation Procedure
1. Connect the thrust pin (6) and the snap ring (5) to
the chain tensioner housing (7).
Notice: When connecting the thrust pin, push in
the thrust pin far enough so that it doesn’t protrude
at the chain tensioner housing.
6. Remove the chain tensioner housing (7) and the
seal (8).
3. Insert the compression spring (4) with the filler
pin (3) into chain tensioner housing.
Tightening Torque
72 - 88 N•m
(53 - 65 lb-ft)
SSANGYONG Y200
1B2-66 M161 ENGINE MECHANICAL
4. Lightly apply the grease to the seal (2) and install
the screw plug (1).
Installation Notice
5. Check for leaks by operating the engine.
Tightening Torque
40 N•m (30 lb-ft)
YAD1B1T0
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст