SsangYong Rexton. Manual — part 323
M162 ENGINE MECHANICAL 1B1-95
SSANGYONG Y200
YAD1B2Z0
YAD1B3A0
4. Remove the drain plug (1) and drain the engine
oil.
Notice: Leave the oil filler cap open to ease the
engine oil discharge.
5. Tighten the engine oil drain plug after cleaning it.
Installation Notice
ENGINE OIL AND OIL FILTER
ELEMENT
Tools Required
103 589 02 09 00 Oil Filter Remover
Replacement Procedure
1. Install the oil filter remover 103 589 02 09 00 on
the oil filter cover.
Notice: Make the screw cover removable by
tightening the bolt at the side of the oil filter
remover 103 589 02 09 00.
2. Install the wrench to the upper bolt in the oil filter
remover 103 589 02 09 00 and remove the oil cover
by turning it.
3. Remove the oil filter element.
Notice: Work with a cloth under the vehicle when
removing the oil filter element to not drain the oil.
Tightening Torque
25 N•m (18 lb-ft)
Replace the seal washer with new one.
6. Replace the O-ring in the oil filter cover with new
one.
Notice: Apply the engine oil to the O-ring.
7. Insert new oil filter element into the oil filter
housing.
8. Temporarily tighten the oil filter cover. Install the
oil filter remover 103 589 02 09 00, and then
completely tighten it.
Installation Notice
Tightening Torque
25 N•m (18 lb-ft)
SSANGYONG Y200
1B1-96 M162 ENGINE MECHANICAL
YAD1B3B0
9. Fill up engine oil through the engine oil filler
opening (3).
10. Check for oil leaks at normal engine temperature
after starting the engine.
11. Stop the engine and wait 5 minutes.
Check the oil level and fill up as specified if
necessary.
M162 ENGINE MECHANICAL 1B1-97
SSANGYONG Y200
OIL FILTER
Preceding Work : Removal of starter motor
Removal of upper intake manifold
1 Coolant Line
2 O-ring . . . . . . . . . . . . . . Replace
3 Clip
4 Hose
5 Bolt . . . . . 22.5-27.5 N•m (16.6-20.3 lb-ft)
6 Oil Filter
7 Gasket . . . . . . . . . . . . ... Replace
YAD1B3C0
SSANGYONG Y200
1B1-98 M162 ENGINE MECHANICAL
YAD1B3D0
Replace the oil filter gasket.
4. Installation should follow the removal procedure
in the reverse order.
5. Check engine oil level.
6. Run the engine at idle and check the engine for
leaks.
3. Remove the oil filter bolt and then remove the oil
filter.
Installation Notice
Removal & Installation Procedure
1. Drain the coolant from the crankcase.
2. Remove the each coolant line and hose.
Tightening Torque
22.5 - 27.5 N•m
(16.6 - 20.3 lb-ft)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст