SsangYong Actyon Sports II. Manual — part 80
02-7
8710-01
1) Wiper and Washer Operations
When pulling up the lever, the wiper
operates once and the wiper lever returns
to the "OFF" position.
Stop the operation.
Operates automatically
according to the vehicle
speed or the amount of rain.
Continuous wipe, slow
operation.
Front Wiping Speed Control Switch
FAST: Fast interval
SLOW: Slow interval
Continuous wipe, fast operation
Front Wiper and Washer Coupled Operation
Pull the lever briefly (below 0.6 seconds):
One wiping cycle without washer spray
Pull and hold the lever for more than 0.6 seconds:
Three wiping cycles with washer spray
Front Auto Washer Switch (AFW)
When the front wiper switch is off and this switch is pressed,
washer fluid will be sprayed and the wiper will automatically
operate 4 times. Then, the fluid will be sprayed again and the
wiper will automatically operate 3 times.
MIST
OFF
AUTO
LO
HI
Previous model
Pressing the switch makes washer
fluid to be sprayed for 2 sec. with four
wiping, after having delay of 0.6 sec.,
washer fluid to be sprayed for 1.5 sec.
with three wiping
Pressing the switch makes washer
fluid to be sprayed for 2 sec. with four
wiping, and washer fluid to be sprayed
for 1.5 sec. with three wiping, with no
delay of time
New model
02-8
2) Operation Logic
▶Wiper MIST and Front Washer Coupled Wiper
The wiper relay is turned on at 0.3 seconds after from the time when the washer switch is turned
on for 0.1 to 0.59 seconds with the ignition switch "ON".If the wiper parking terminal gets off, the
wiper relay is turned off.
-
The wiper relay is turned on at 0.3 seconds after from the time when the washer switch is turned
on for more than 0.6 seconds with the ignition switch "ON". The wiper relay gets on 3 times
immediately after turning off the washer switch.
-
02-9
8710-01
When the washer switch is turned on for more than 0.6 seconds during the wiper operation by
INT switch, the operation in step (2) is performed.
When it is turned on for a certain period of time (0.1 to 0.59 seconds), the operation in step (1) is
performed.
-
02-10
▶Auto Washer and Wiper Switch (AFW)
When the auto washer switch is turned on with the ignition switch "ON" and the INT switch
"OFF", the washer motor output gets ON for 1 second. If the system recognizes the output signal,
the wiper relay output gets ON during 4 cycles and the washer motor output gets ON for 1
second. Then, the wiper relay output gets OFF after 3 cycles.
-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст