Isuzu Rodeo UE. Manual — part 514
7B–88
MANUAL TRANSMISSION
Reassembly
1. Use a hydraulic press, installer J–6133–1 and bearing
and gear puller J–22912–01 to install the input shaft
bearing(1) onto the input shaft(1).
226RS157
2. Using petroleum jelly, install the 15 rollers(3) and
spacer(4) into the rear of the input shaft(2). Also
install the mainshaft thrust bearing(5) and its race(6)
in the rear of the input shaft(2).
MANUAL TRANSMISSION
7B–89
Input Bearing Retainer (TREMEC T5R)
Disassembled View
226RS158
Legend
(1) Input Bearing Retainer
(2) Input Shaft Seal
(3) Shim
(4) Bearing Outer Race
Disassembly
If you have not done so previously, remove these parts
from the input bearing retainer(1):
f
Bearing outer race(4)
f
Shim(s) (3)
226RS159
1. Remove the input shaft seal(2), using Input seal
remover J–29369–2 and slide hammer J–23907.
226RS160
Reassembly
1. Install the input shaft seal(2) in the retainer(1), using
the installer J–37375 and a soft-faced hammer.
2. Install the input bearing outer race(4) in the
retainer(1) without the shim(3) behind it.
226RS161
7B–90
MANUAL TRANSMISSION
Counter Shaft (TREMEC T5R)
Disassembled View
226RS162
Legend
(1) Counter Shaft Front Bearing Outer Race and
O–ring
(2) Counter Shaft Front Bearing
(3) Counter Shaft
Disassembly
1. Using a hydraulic press and bearing race receiver and
case support J–37358, remove the counter shaft front
bearing outer race(1).
Remove the O-ring(1).
226RS163
2. Remove the counter shaft front bearing(2) from the
counter shaft(3). Use a hydraulic press, couter shaft
front bearing remover J–37359 and bearing and gear
puller J–22912–01.
226RS164
MANUAL TRANSMISSION
7B–91
Reassembly
1. Install the counter shaft front bearing(2) onto the
counter shaft(3), using a hydraulic press, installer
J–37357 and bearing and gear puller J–22912–01.
226RS165
2. Install a new O-ring(1) on the counter shaft outer
race(1) and lubricate it.
226RS166
3. Using installer and driver handle, lightly tap the outer
race(1) into its bore until the O-ring is compressed.
4. Using a hydraulic press, installer J–37357 and driver
handle J–8092, install the outer race(1) until its
shoulder rests on the inside of the case.
226RS167
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст