Isuzu Rodeo UE. Manual — part 88
TRANSFER CASE
4D–15
15. Use the punch J–39209 to stake the rear companion
flange nut (3) at two spots.
266RS001
266RW002
16. Stake the front companion flange nut (2) at one spot.
NOTE: Be sure to confirm that there is no crack at the
staked portion of the flange nut after staking.
17. Install the O–ring (23) to the speedometer driven gear
bushing (22).
18. Install the driven gear to the speedometer driven gear
bushing (22).
19. Install the speedometer driven gear assembly to the
transfer rear cover.
20. Install the plate (21) to the transfer rear case and
tighten to the specified torque.
Torque: 15 N·m (11 lb ft)
21. Install the speedometer sensor and tighten to the
specified torque.
Torque: 27 N·m (20 lb ft)
225RW004
Legend
(20) Bolt
(21) Plate
(22) Bushing
(23) O–ring
4D–16
TRANSFER CASE
Transfer Rear Cover Assembly
226RW154
Legend
(1) Rear Output Shaft Assembly
(2) Rear Output Shaft
(3) Bearing Snap Ring
(4) Ball Bearing
(5) Bearing Snap Ring
(6) Ball
(7) Speedometer Drive Gear
(8) Ball Bearing
(9) Transfer Rear Cover (with oil seal)
Disassembly
1. Remove bearing snap ring, use a pair of snap ring
pliers to remove the snap ring (3).
226RS060
TRANSFER CASE
4D–17
2. Remove the rear output shaft assembly (1) from the
transfer rear cover (with oil seal) (9).
3. Remove ball bearing (8), using a bench press and the
bearing remover J–22912–01.
226RS061
4. Remove speedometer drive gear (7).
5. Remove ball (6).
6. Remove bearing snap ring (5), using a pair of snap
ring pliers.
7. Remove rear output shaft (2) from the ball bearing (4),
using a bench press and the bearing remover
J–22912–01.
226RS062
Inspection and Repair
Refer to “TRANSFER CASE ASSEMBLY” in this section
for inspection and repair.
Reassembly
Transfer rear cover (with oil seal) (9). Oil seal
replacement.
f
Remove the oil seal from the transfer rear cover.
f
Apply engine oil to the oil seal outer surfaces.
f
Fill in recommended grease (BESCO L2) or
equivalent in the oil seal lip.
f
Use the oil seal installer J–39208 to install the rear oil
seal to the transfer rear cover.
220RS019
1. Install ball bearing (4) to the rear output shaft (2),
using the ball bearing installer J–37223 and the
adapter J–37486–A.
262RW021
4D–18
TRANSFER CASE
2. Install bearing snap ring (5), using a pair of snap ring
pliers.
3. Install ball (6).
4. Install speedometer drive gear (7).
226RS064
5. Use the ball bearing installer J–37223 to install the
ball bearing (8).
226RS065
6. Install the rear output shaft assembly (1) to the
transfer rear cover (9).
7. Install bearing snap ring (3).
NOTE: The snap ring must be fully inserted into the
transfer rear cover snap ring groove.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст