Isuzu Rodeo UE. Manual — part 615

8F–33

BODY STRUCTURE

Removal

1. Disconnect the battery ground cable.
2. Remove power window switch/regulator handle.

f

Pry out the power window switch and remove the
connectors.

635RW004

f

To remove the regulator handle (1), remove the clip
(2) at the root of the handle by using wire with hook.

631RW004

3. Remove the screw while pulling the inside lever

toward you and then remove the inside handle.

632RW003

4. Remove speaker grille (3).

f

Pull out the front side of the grille.

5. Remove speaker assembly (2).

f

Remove 4 screws and disconnect the speaker
harness connector (1).

635RW002

8F–34

BODY STRUCTURE

6. Remove door mirror cover.
7. Remove grip cover.
8. Remove 5 screws (1), (3) and pull out the trim panel at

the 6 clip positions (2).

635RW007

9. Remove waterproof sheet.

10. Remove 2 screws through the access hole and pull

out the glass upward.

631RW006

631RW007

11. Remove window regulator.

f

Disconnect the window regulator motor harness
connector, if equipped with power windows.

12. Remove glass run.

f

Pull the glass run (6) out from the door frame
groove.

631RS007

8F–35

BODY STRUCTURE

Installation

To install, follow the removal steps in the reverse order,
noting the following points:

1. Install the regulator handle as shown in the

illustration, if equipped without power windows.

631RW005

2. Check to see that the window regulator operates

smoothly and the glass opens and closes properly.
Install the waterproof sheet with no clearance
between the door panel and the waterproof sheet.

8F–36

BODY STRUCTURE

Rear Window Regulator, Glass and Glass Run

Parts Location

655RW001

Legend

(1) Glass Run
(2) Glass
(3) Fixed Glass
(4) Window Regulator
(5) Outside Handle
(6) Door Lock Assembly
(7) Bracket

(8) Rear Corner Garnish
(9) Door Trim Panel

(10) Courtesy Light Lens

(11) Power Window Switch/Window Regulator

Handle

(12) Inside Handle
(13) Waterproof Sheet
(14) Waist Seal