Isuzu KB P190. Manual — part 1192
Manual Transmission (MUX) 7B1-49
• The bearing must be press fitted with end surface of
shaft.
• The outer race must not be punch. (Inner race to be
punch.)
7B1-50 Manual Transmission (MUX)
Output Shaft Assembly
Component
Legend
1. Output shaft (4x2 model)
2. Output shaft (4x4 model)
3. Output front bearing inner race
Removal
1. Break the output front bearing cage with hammer
and chisel.
Remove the output front bearing inner race, and
discard the used inner race.
Installation
1. Use a bench press and installer 5-8840-2847-0 (1)
to install the output front bearing inner race to the
output shaft.
• Never reinstall the used output front bearing
inner race.
• Apply grease (BESCO L-2 or equivalent) to the
bearing roller.
Notice:
• The bearing innner race must be press fitted to end
surface of gear.
• The cage must not be push.
RTW77BSF000801
1
2
3
3
RTW77BSH002601
1
Manual Transmission (MUX) 7B1-51
Shift & Select Rod Assembly
Component
Legend
1. Snap ring
2. Shift & select block
3. Shift rod bracket
4. Interlock upper block
5. Internal common upper lever
6. Interlock middle block
7. Interlock lower block
8. Internal common lower lever
9. Shift & select rod
Removal
1. Remove the snap ring from the interlock lower
block lower side.
2. Remove the interlock lower block.
3. Remove the internal common lower lever.
4. Remove the interlock middle block.
5. Remove the internal common upper lever.
6. Remove the snap ring from the shift & select block
upper side.
7. Removel the shift & select block.
8. Removel the shift rod bracket.
9. Remove the snap ring from the interlock upper
block upper side.
10. Remove the interlock upper block.
Installation
1. Install the interlock upper block.
2. Install the new snap ring to the interlock upper
block upper side.
• Never reinstall the used snap ring.
Notice:
The snap ring must be assembled in groove of rod
surely.
3. Install the shift rod bracket.
4. Install the shift & select block.
5. Install the new snap ring to the shift & select block
upper side.
• Never reinstall the used snap ring.
RTW77BMF000901
1
2
3
1
4
5
6
1
7
8
9
7B1-52 Manual Transmission (MUX)
Notice:
The snap ring must be assembled in groove of rod
surely.
6. Install the internal common upper lever.
7. Install the interlock middle block.
8. Install the internal common lower lever.
9. Install the interlock lower block.
10. Install the new snap ring to the interlock lower
block lower side.
• Never reinstall the used snap ring.
Notice:
The snap ring must be assembled in groove of rod
surely.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст